Abstract:Presented in this invited lecture are systematic investigation results of the heat transfer and pressure drop characteristics for three classes of heat transfer enhancement surfaces. These are plate arrays with an oblique angle to the flow direction, plate fin-and-tube surfaces and the circular tubes with wave-like longitudinal fins and a blocked-center. For the plate arrays, it is found that from the identical pumping power and identical pressure drop constraints the best oblique angle is around 30 degrees; the non-uniformity in the successive plate length may enhance heat transfer by about 20 %, and at the very low Reynolds number region, both heat transfer and friction factor exhibit characteristics of flow and heat transfer in a straight duct. General correlations of heat transfer and friction factor are presented for four types of plate fin-and-tube exchanger surfaces, these are plain plate fin, slotted fin, plate fin with triangular cross section and plate fin with sinusoidal cross section. Results show that heat transfer is a weak function of both fin spacing and tube row number, while the friction factor is nearly independent of the tube row number. Experiments also show that the interwall cylinder between the plates can enhance the heat transfer and promote the transition from laminar to turbulent flow. For the circular tube with wave-like longitudinal fins and a blocked center-part, a general heat transfer correlation obtained from six tubes with different wave numbers is provided. Because of the small hydraulic diameter, and the extended surface, the tube side heat transfer of air can be greatly enhanced. Moreover, the blockage of the center part may further enhance the heat transfer..

HEAT TRAN SFER AND FLUID FLOW O F AIR ACRO S S CORRU GATED TUB E BUNDL ES

HEAT TRANSFER AND FLUID FLOW OF AIR ACROSS CORRUGATED TUBE BUNDLES

Experimental Study on the Pressure Drop and Heat Transfer Characteristics in Corrugated Tubes

Pressure Drop, Heat Transfer and Performance of Single-Phase Turbulent Flow in Spirally Corrugated Tubes

Convective Heat Transfer and Pressure Drop of Annular Tubes with Three Different Internal Longitudinal Fins

Heat Transfer Study of a Hybrid Smooth and Spirally Corrugated Tube

Heat Transfer and Flow Resistance in Crossflow over Corrugated Tube Banks

Heat Transfer Characteristics of Air Cross-Flow for In-Line Arrangement of Spirally Corrugated Tube and Smooth Tube Bundles

Numerical Investigation of Tube-Side Fully Developed Turbulent Flow and Heat Transfer in Outward Corrugated Tubes

Experimental Study on the Pressure Drop and Heat Transfer of Two Different Tubes With Plain-Rectangle Internal Fins

Air-side Heat Transfer Characteristics under Wet Conditions at Lower Ambient Pressure of Fin-and-tube Heat Exchanger

Thermohydraulic analysis of hybrid smooth and spirally corrugated tubes

Experimental and numerical characterization of single-phase pressure drop and heat transfer enhancement in helical corrugated tubes

Experimental Study on Heat Transferring Augmentation in Corrugated Tubes

Numerical Analysis of Air Flow Resistance and Heat Transfer Between Corrugated Plates with Channels of Varied Heights

INVESTIGATION ON HEAT TRANSFER ENHANCEMENT AND VELOCITY MATCHING IN HEAT EXCHANGERS BY USING CORRUGATED TUBES

Numerical investigation on falling film flow and heat transfer characteristics over corrugated plates

Convective Heat Transfer and Pressure Drop of a Tube with Internal Longitudinal Fins

Some Enhancement Studies For Laminar And Tuebulent Heat Transfer Of Air In Tubes And Across Plates

Effect of fin spacing on heat transfer and pressure drop of two-row corrugated-fin and tube heat exchangers

The numerical simulation research for the heat transfer and flow of the large-scale helically corrugated pipe