Abstract:This paper presents design techniques for an energy-efficient multi-lane receiver (RX) with baud-rate clock and data recovery (CDR), which is essential for high-throughput low-latency communication in high-performance computing systems. The proposed low-power global clock distribution not only significantly reduces power consumption across multi-lane RXs but is capable of compensating for the frequency offset without any phase interpolators. To this end, a fractional divider controlled by CDR is placed close to the global phase locked loop. Moreover, in order to address the sub-optimal lock point of conventional baud-rate phase detectors, the proposed CDR employs a background eye-climbing algorithm, which optimizes the sampling phase and maximizes the vertical eye margin (VEM). Fabricated in a 28nm CMOS process, the proposed 4x32Gb/s RX shows a low integrated fractional spur of -40.4dBc at a 2500ppm frequency offset. Furthermore, it improves bit-error-rate performance by increasing the VEM by 17%. The entire RX achieves the energy efficiency of 1.8pJ/bit with the aggregate data rate of 128Gb/s.

A 30mw/channel 4&#x00d7;25gbps Baud-Rate Bang-Bang CDR Using an Integrating Receiver Based Data Sampling

A 51gb/s, 320mw, PAM4 CDR with Baud-Rate Sampling for High-Speed Optical Interconnects

A 48mw 15-to-28gb/s Source-Synchronous Receiver with Adaptive DFE Using Hybrid Alternate Clock Scheme and Baud-Rate CDR in 65nm CMOS.

A 40 Gb/s 74.9 mW PAM4 receiver with novel clock and data recovery

A 25gbps, 2X-Oversampling Cdr Using A Zero-Crossing Linearizing Phase Detector

A 112-Gb/s PAM-4 Receiver with Ultra-Fine GainAdjustment CTLE and Novel Sample-and-Reset Slicer in 28-Nm CMOS

A 4x32Gb/s 1.8pJ/bit Collaborative Baud-Rate CDR with Background Eye-Climbing Algorithm and Low-Power Global Clock Distribution

A 12.5gbps Dual Loop Quarter Rate Cdr Using Lock Detecting Technique In 55nm Cmos Process

A 10gbps Half-Rate Digital Clock and Data Recovery Circuit for 60ghz Receiver in 65nm CMOS

A Sub-0.25-pJ/bit 47.6-to-58.8-Gb/s Reference-Less FD-Less Single-Loop PAM-4 Bang-Bang CDR With a Deliberate-Current-Mismatch Frequency Acquisition Technique in 28-nm CMOS

A 50gb/S-Pam4 Cdr With On-Chip Eye Opening Monitor For Reference-Level And Clock-Sampling Adaptation

A 40gb/s PAM4 Baud-Rate CDR with Equal-Slope Algorithm

A Fully-Integrated 25gb/s Low-Noise TIA+CDR Optical Receiver Designed in 40Nm-Cmos.

A 40Gbps quarter rate CDR using CMOS-style signal alignment strategy in 65nm CMOS

A 1.25-8.5 Gb/s Wide Range CDR with Locking Detector in 40 Nm CMOS Technology

A 1-Gbps reference-less burst-mode CDR with embedded TDC in a 65-nm CMOS process.

A 60-Gb/s 1.2-pJ/bit 1/4-Rate PAM-4 Receiver With a Jitter Compensation CDR

Design Of 56 Gb/Spam4 Wire-Line Receiver With Ring Vco Based Cdr In A 65 Nm Cmos Technology

A 25gb/s 185mw PAM-4 Receiver with 4-Tap Adaptive DFE and Sampling Clock Optimization in 55nm CMOS

A 10Gbps CDR based on phase interpolator for source synchronous receiver in 65nm CMOS

A 30mw/channel 4&amp;#x00d7;25gbps Baud-Rate Bang-Bang CDR Using an Integrating Receiver Based Data Sampling