Abstract:This paper presents the development of a hybrid model for simulating a vertical U-tube geothermal heat exchanger under actual climate.The model consists of a 3D model representing a pair of U-tubes buried in symmetric boreholes and a supplementary 2D model that can be applied to real site scenarios.The temperature series at the wall of the borehole and initial soil temperatures at different depths derived from the simulation results of the 3D model serve as the input boundary conditions of the 2D model.Hence,the hybrid model shares the respective advantages of both subordinate models and therefore provides comprehensive simulation resuhs that span approximately 10 months at a slight cost in implementation complexity.Meanwhile,the model is limited by numerous assumptions such as the consistency between the ground surface and air temperatures and physical uniformity of the materials.Simulations were performed based on the conditions obtained at a real site in the city of Hangzhou.The simulation time range was June 12,2015,to March 17,2016,which covered an entire cooling,transition,and heating season.The collected data revealed that the soil within an effective radius of 2 m gained an absolute increase in internal energy of 0.292 MJ after the simulation.The relative increases in the internal energy and average temperature were 1.037 MJ and 0.28 K,respectively,compared to those affected only by climate,which indicated an unwanted accumulation of heat beneath the ground.Moreover,the temperature at a deeper soil depth showed a lag in phase behind that of a shallower depth.This lag was approximately 2 weeks between a point at the center of the entrance and exit of the U-tubes and a point 1 m below it.Moreover,the fluctuation patterns of the inlet/outlet fluid temperatures showed a significant shift from the air temperature toward the annual averages,which were-8.313 K in the cooling season and 9.077 K in the heating season.Finally,the temperature distribution among pipe-clusters at different depths showed that the heat accumulation mainly occurred at a depth greater than 7 m,and the accumulation was more severe at a shallower depth and at the corners of clusters.

Estimation Method of Layered Ground Thermal Conductivity for U-tube BHE Based on the Quasi-3D Model

Multi-factor Optimization of Thermo-Economic Performance of Coaxial Borehole Heat Exchanger Geothermal System Based on Levelized Cost of Energy Analysis

Estimation Method for Layered Ground Thermal Conductivity Using Genetic Algorithm Based on a 2-D Heat Transfer Model

Cylindrical surface model of ground source heat pump considering soil stratification

Numerical Simulation and Analysis on the Heat Transfer of the Vertical Ground Heat Exchanger in Hydrous Soil

Estimation of Ground Thermal Properties for Coaxial BHE Through Distributed Thermal Response Test

Estimation of Layered Ground Thermal Properties for Deep Coaxial Ground Heat Exchanger

Hybrid 3D and 2D Numerical Models of Geothermal Heat Exchanger for Ground Source Heat Pump System

Performance Evaluation Of Borehole Heat Exchanger In Multilayered Subsurface

Analysis on heat transfer performance of coaxial borehole heat exchanger in a layered subsurface with groundwater

Analysis of thermal interaction coefficient for multiple borehole heat exchangers in layered soil considering groundwater seepage

Study the Performance of Borehole Heat Exchanger Considering Layered Subsurface Based on Field Investigations

Analytical model of heat transfer of U-shaped borehole heat exchanger under convolution theory and its optimal heat extraction analysis

Prediction and Parametric Analysis of 3D Borehole and Total Internal Thermal Resistance of Single U-tube Borehole Heat Exchanger for Ground Source Heat Pumps

A Case Study of Field Thermal Response Test and Laboratory Test Based on Distributed Optical Fiber Temperature Sensor

Parameters Optimization of Borehole and Internal Thermal Resistance for Single U-tube Ground Heat Exchangers Using Taguchi Method

Numerical study on the heat performance of enhanced coaxial borehole heat exchanger and double U borehole heat exchanger

An analytical heat transfer model for the mid-deep U-shaped borehole heat exchanger considering groundwater seepage

Numerical simulation of soil temperature field surrounding vertical U tube heat exchanger for ground coupled heat pump

Heat Transfer Analysis of a Borehole Heat Exchanger Array in a Layered Subsurface

A New Method to Determine the Thermal Properties of Soil for Vertical-Borehole Ground-Source Heat Pump Systems