Abstract:This article presents a wideband millimeter-wave power amplifier (PA) with a capacitive stability enhancement technique. It is composed of three differential cascode stages to attain high-power gain and large output power. To ensure the stabilization of the amplifier, a robust technique based on a series base capacitor is proposed and applied in each stage. Each capacitor creates a low-frequency zero to adjust the phase and amplitude responses of the differential cascode structure. As a result, the phase margin of the loop gain is increased remarkably. By adjusting the series base capacitors, the low-frequency zeros and gains of the three stages can be optimized. Therefore, the operating bandwidth is also extended. Meanwhile, a transformer-based four-path power combination network with a large current capacity is developed to further enlarge the output power. The circuit is demonstrated in a commercial 0.13 μm SiGe BiCMOS process. According to the measurement results, the PA obtains a saturated output power (P Sat ) of 18.5 dBm and output referred 1-dB compression point (OP 1dB ) of 16.32 dBm at 77 GHz. The tested small-signal gain is 26.7 dB at 77 GHz. Its 3 dB gain bandwidth is beyond 21.5 GHz, which ranges from 68.5 to 90 GHz. The P Sat variation is less than 0.57 dB at the frequency range from 70 to 85 GHz. The measurement also shows the PA with the proposed technique is unconditionally stable over the entire frequency band. The chip area is only 0.684 mm 2 .

A 6–18 GHz Bulk CMOS Three-Stage Gain-Compensation Amplifier for Phased-Array Radar System

Robustness‐oriented P‐band Phased Array Radar Front‐end with High Phase and Gain Resolution in 0.18 BiCMOS

A 90-98-ghz FMCW Radar Transceiver Supporting Broadband Modulation in 65nm CMOS

Ultra-wideband high gain low group delay variation amplifier for phased-array radar system

A C-Band Compact High-Linearity Multibeam Phased-Array Receiver With Merged Gain-Programmable Phase Shifter Technique

Fully integrated pseudo differential K-band power amplifier in 0.13um standard CMOS

A 54-67-ghz Low-Power Highly-Integrated Transceiver in 65-Nm CMOS for FMCW Radar Applications

A 68.5~90 GHz High-Gain Power Amplifier with Capacitive Stability Enhancement Technique in 0.13 Μm SiGe BiCMOS

A 100–117 GHz W-Band CMOS Power Amplifier With On-Chip Adaptive Biasing

A 56 – 65 GHz Highly-Integrated FMCW Radar Transceiver with 7.8 Db NF and 8 GHz Chirp-Bandwidth in 65-Nm CMOS

An 8–18 GHz Power Amplifier with Novel Gain Fluctuation Compensation Technique in 65 Nm CMOS

A 13.5–19 GHz 20.6-Db Gain CMOS Power Amplifier for FMCW Radar Application

A 94ghz 2×2 Phased-Array FMCW Imaging Radar Transceiver with 11dbm Output Power and 10.5db NF in 65nm CMOS

A Gm-Compensated 46-101 GHz Broadband Power Amplifier for High-Resolution FMCW Radars.

Design Considerations of Ku-band High Gain Wideband CMOS Power Amplifier for FMCW Radar Application

A 1∼4GHz Tri-Directional RF Amplifier Based on CMOS Technology for Digital Array Radars

A Ka-Band Low Noise Amplifier for Phased Array Radar System in 65nm CMOS

A Fully Integrated X-Band Phased-Array Transceiver in 0.13-Μm CMOS Technology

A 90 GHz Broadband Balanced 8-Way Power Amplifier for High Precision FMCW Radar Sensors in 65-nm CMOS

C-band 180-Nm CMOS Transmitter Front-End with a Three-Stage Power Amplifier for Phased Array Applications

Broadband and Integratable 2 × 2 TWT Amplifier Unit for Millimeter Wave Phased Array Radar