Abstract:This paper presents a 27.7-31.2 GHz highly integrated 8-element 4-beam transmitter front end in 65-nm CMOS for phased-array applications. The proposed hybrid variable-gain amplifier (VGA) combines digital common-source (CS) VGA and analog Gilbert-cell-based VGA to realize a large tuning range and high resolution simultaneously. Furthermore, the proposed VGA scheme also integrates with an active combining network to implement a compact multi-beam structure. In the vector-modulation-based phase shifter (PS), low/high pass lumped delay lines are inserted between CS transistors and common-gate (CG) transistors to form I/Q signals which drive four pairs of Gilbert-cell based G(m)-arrays for different phase states. In addition, the output element leverages a symmetrical transformer-based Doherty power amplifier (PA) and an analog adaptive bias to improve the power-back-off (PBO) efficiency with a high peak-to-average-ratio (PAPR) modulation signal. With a 1.1-V supply voltage, this front end achieves a saturated output power (P-sat) of 19.2 dBm with a 20.5% channel efficiency and a 1-dB compression point (OP1dB) of 18.2 dBm. The measured maximum drain efficiency (DE) is 40.8% and 6-dB PBO DE is 28%. Compared with class-B/A PAs, the DE is improved by 40%/180%. The proposed hybrid VGA achieves a 27-dB tuning range and a 0.25-dB gain step with 0.26 dB/1.9 degrees RMS gain/phase errors. The active PS implements 6-bit 360 degrees phase shifting with 0.25 dB/2.5. RMS gain/phase errors.

An 8–18 GHz Power Amplifier with Novel Gain Fluctuation Compensation Technique in 65 Nm CMOS

Design of X/Ku Dual-Wideband GaN Power Amplifier MMIC Based on Coupled Multiresonator Matching Networks

A 68.5~90 GHz High-Gain Power Amplifier with Capacitive Stability Enhancement Technique in 0.13 Μm SiGe BiCMOS

A Ka-band 8-Element 4-Beam Transmitter Front End with Hybrid VGA and Symmetrical Transformer-based Doherty PA

A 100–117 GHz W-Band CMOS Power Amplifier With On-Chip Adaptive Biasing

Fully integrated pseudo differential K-band power amplifier in 0.13um standard CMOS

A 30-680-mhz GaAs Phemt Power Amplifier with Guanella-type Transformers Integrated on a Flexible Printed Circuit Board

Design and Analysis of a 26–34.5-Ghz Power Amplifier with Balanced Mismatch Reduction and Interstage Matching

A Compact Multilayer-Stacked Guanella Transformer Based 50–680-Mhz GaAs Power Amplifier

A 13.5–19 GHz 20.6-Db Gain CMOS Power Amplifier for FMCW Radar Application

An 8-18Ghz Class-Ab Power Amplifier with 16dbm Output Power and 23% PAE over Entire X-Ku Band

A 90 GHz Broadband Balanced 8-Way Power Amplifier for High Precision FMCW Radar Sensors in 65-nm CMOS

A 22.8 GHz to 32.8 GHz Compact Power Amplifier with a 15 Dbm Output P1dB and 36.5% Peak PAE in 65-Nm CMOS.

Design Considerations of Ku-band High Gain Wideband CMOS Power Amplifier for FMCW Radar Application

A Gm-Compensated 46-101 GHz Broadband Power Amplifier for High-Resolution FMCW Radars.

A Compact 0.1-19.7Ghz Ultra-Wideband Power Amplifier with ±0.5db Gain Ripple in 28 Nm CMOS Process

A 26.4-Db Gain 15.82-Dbm 77-Ghz CMOS Power Amplifier with 15.9% PAE Using Transformer-Based Quadrature Coupler Network

A Ku-Band Broadband Stacked FET Power Amplifier Using 0.15 μm GaAs pHEMT

A 38-48 GHz Power Amplifier with 23-dB Gain 18.5-dBm Psat and 28% PAE in 65-nm CMOS

A Wideband Power Amplifier in 65 nm CMOS Covering 25.8 GHz–36.9 GHz by Staggering Tuned MCRs

An Excellent Gain Flatness 3.0–7.0 GHz CMOS PA for UWB Applications