Abstract:Phosphorus recovery from dephosphorization slag generated during steelmaking has enormous potential to secure a stable supply of phosphate. Because P and Fe in slag are concentrated in different mineral phases, P can be recovered by separation of the P-bearing phase, and the residue can be reutilized in steel plant at the same time. In the present study, we adopted selective leaching of P and investigated the effects of leaching parameters on the dissolution behavior of slag. It was determined that with the decrease in particle size and increase in stirring speed, the P dissolution ratio increased significantly. When particle size was less than 53 μm and stirring speed exceeded 200 rpm, most of the P-bearing C2S−C3P solid solution was dissolved and separated. Increasing temperature and decreasing the mass ratio of slag to liquid had a slight influence on promoting P dissolution, while the Si dissolution was significantly suppressed in the case of high temperature and mass ratio due to the formation of silica gel. The P dissolution ratio reached 84.9%, and the Fe dissolution was negligible. Through selective leaching, the residue primarily consisting of magnesioferrite could be used as a flux in steelmaking process. The shrinking core model was successfully used to describe the dissolution kinetics of P. As temperature increased, apparent rate constant increased slightly. The calculated activation energy was 9.23 kJ/mol, demonstrating that the P dissolution was controlled by diffusion in the residue layer.Graphical AbstractMost of the P-bearing solid solution in dephosphorization slag was dissolved and the dissolution of Fe-bearing phase was negligible, achieving selective leaching of P. The P dissolution from slag was controlled by diffusion in the residue layer.

A Low-Cost Method Using Steel-Making Slag to Quench the Residual Phosphorus from Wastewater Effluent

Phosphorus Removal Efficiency of Hydrothermally Modified Granular Steel Slag

Phosphorus Removal from Wastewater by Adsorption on Blast Furnace Slag

Preferential Removal of Phosphorus Using Modified Steel Slag and Cement Combination for Its Implications in Engineering Applications

Separation and recovery of phosphorus from steelmaking slag via a selective leaching–chemical precipitation process

Leaching of Phosphorus from Quenched Steelmaking Slags with Different Composition

Phosphorus and nitrogen removal from water using steel slag in soil-based low-impact development systems

Analysis on Removal Efficiency of Phosphorus by Using Steel Slag As Substrate Materials of Vertical-flow Constructed Wetland Systems

Phosphorus Removal from Wastewater Using Electric Arc Furnace Slag Aggregate

Preparation of modified steel slag and its phosphate removal performance

Notice of RetractionHydrothermal Modification of Granular Steel Slag for Phosphate Removal

Hydrothermal modification of granular steel slag for phosphate removal

Remove and Recover Phosphorus During Anaerobic Digestion of Excess Sludge by Adding Waste Iron Scrap

Preparation of magnesium-modified steel slag and its adsorption performance for simultaneous removal of nitrogen and phosphorus from water

Separation of Phosphorus from Phosphorus-concentrated Steelmaking Slag

Efficient extraction of phosphate from dephosphorization slag by hydrochloric acid leaching

A Kinetic Study on Selective Leaching of Phosphorus from Dephosphorization Slag

Phosphate Removal from Solution Using Steel Slag Through Magnetic Separation

Phosphorus Extraction from Synthesized Steelmaking Slag by Hydrothermal Hydroxyapatite Precipitation

Recycled Steel Slag as a Porous Adsorbent to Filter Phosphorus-Rich Water with 8 Filtration Circles

Application of steel slag to the environmental pollution treatment and its research progress