Abstract:Phosphorus (P) is one of the essential nutrients for all life but also is involved in the major factor of water eutrophication. This study aimed to investigate a low-cost approach for highly efficient P removal and recovery from wastewater with blast furnace slag (BFS) as the adsorbent. The adsorption characteristics were consistent with the Langmuir adsorption isotherm (q(0) 0.1370 similar to 0.3848 mg/g) and quasi-secondary kinetic model (R-2 = 0.9986 similar to 0.9997), suggesting monomolecular-layer chemical adsorption might be the dominant pathway. According to the determination of scanning electron microscope and energy dispersive spectroscopy, P was distributed uniformly with other elements in the surface of BFS and even formed needle-like crystals. This indicated that P might be also further deposited in the surface of BFS after the initially chemical adsorption via coordination with the active sites, which led to the slow accumulation of P along with the adsorption experiments. The binding energy and atomic composition analysis of X-ray photoelectron spectroscopy revealed that phosphate mainly existed as HPO42- in the surface of BFS, especially for those non-magnetic particles with relative low Fe content (<30%), indicating the preference of P to the hydroxyl basic sites. Compared with those magnetic particles, the adsorption capacity of the non-magnetic particles was larger and could be restored more easily with the elution of sulfate acid, resulting in about two times the P recovery capability. Based on the P adsorption mechanism in the surface of BFS, the operation conditions of the BFS adsorption column for P recovery were optimized in an alkaline condition with a low phosphate concentration and long residual time. Therefore, non-magnetic BFS with small size could be used to recover P resources from rural wastewater with low P concentration and facilitated the on-site reuse of P resources in rural districts.

Phosphorus Removal from Wastewater Using Electric Arc Furnace Slag Aggregate

Phosphorus Removal from Wastewater by Adsorption on Blast Furnace Slag

Preferential Removal of Phosphorus Using Modified Steel Slag and Cement Combination for Its Implications in Engineering Applications

Phosphorus Adsorption on Blast Furnace Slag with Different Magnetism and Its Potential for Phosphorus Recovery

Remove and Recover Phosphorus During Anaerobic Digestion of Excess Sludge by Adding Waste Iron Scrap

Separation and recovery of phosphorus from steelmaking slag via a selective leaching–chemical precipitation process

Electrochemical Removal and Recovery of Phosphorus from Wastewater Using Cathodic Membrane Filtration Reactor

Efficient extraction of phosphate from dephosphorization slag by hydrochloric acid leaching

MECHANISM OF PHOSPHORUS ADSORPTION FROM AQUEOUS SOLUTION ON STEEL CONVERTER SLAGS

Adsorption of Phosphorus from Aqueous Solution on Steel Converter Slags

Performance and mechanism of phosphorus removal by slag ceramsite filler

Phosphorus Removal Efficiency of Hydrothermally Modified Granular Steel Slag

A Kinetic Study on Selective Leaching of Phosphorus from Dephosphorization Slag

Mechanisms of Phosphate Removal from Aqueous Solution by Blast Furnace Slag and Steel Furnace Slag

Steel Slag Filters to Upgrade Phosphorus Removal in Constructed Wetlands: Two Years of Field Experiments

Heavy metal adsorption changes of EAF steel slag after phosphorus adsorption.

A Low-Cost Method Using Steel-Making Slag to Quench the Residual Phosphorus from Wastewater Effluent

Phosphates Recovery through Hydroxyapatite Crystallization from Wastewater Using Converter Slag as a Seed Crystal

Leaching behavior and microstructure of phosphorus in converter slag

Phosphorus Removal by Laboratory-Scale Unvegetated Vertical-Flow Constructed Wetland Systems Using Anthracite, Steel Slag and Related Blends As Substrate.

Acid treatment enhances phosphorus release and recovery from waste activated sludge: Performances and related mechanisms