Thermodynamic Analysis of a Novel Vapor-Injection Joule-Thomson Refrigeration Cycle with a Binary Hydrocarbon Mixture for −86 °C Freezer

Jiarui Liu,Ye Liu,Jianlin Yu,Gang Yan
DOI: https://doi.org/10.1016/j.applthermaleng.2023.120835
IF: 6.4
2023-01-01
Applied Thermal Engineering
Abstract:This paper proposes a novel vapor-injection Joule-Thomson refrigeration cycle with mixed-refrigerant. The introduction of the compressor with vapor-injection can reduce the pressure ratio of each compression stage, thus reducing the compressor power and discharge temperature. The thermodynamic analysis results show that the performance of the novel cycle is better than that of the basic Joule-Thomson cycle. In addition, this paper studies the binary hydrocarbons applied in -86 ? freezers, and find a binary hydrocarbon R601a/R1150 with Superior performance. The mass fractions of R1150 in R601a/R1150 corresponding to the maximum COP of the novel cycle and basic cycle are 0.45 and 0.44, respectively. Moreover, the maximum COP of the novel cycle is 19.25% higher than that of the basic cycle. The comparison results demonstrate that the novel cycle has a great energy-saving potential. In addition, at different condenser outlet temperatures of 16 ?, 25 ? and 32 ?, both cycles have the optimal condensation pressure of 300 kPa, 500 kPa and 650 kPa with respect to COP. For the novel cycle, the compressor injection ratio has little effect on COP. The increase of intermediate pressure can improve cycle performance, but too high intermediate pressure is not conducive to the normal operation of the system. Furthermore, the exergy analysis result shows that the location of the largest exergy destruction rate is in the compressors for both cycles, followed by the recuperators, condensers, evaporators, and capillary tubes.
What problem does this paper attempt to address?