Abstract:This article presents an 18 similar to 30 GHz vector-sum phase shifter for wireless application in the millimeter-wave regime. It is composed of an I/Q signal generator, two variable-gain amplifiers (VGA), and a digital-to-analog converter with a quadrant selector. To attain wideband quadrature signal, a two-stage hybrid based on transformers is proposed to realize the I/Q signal generator. The first- and second-stage hybrids are designed with different resonating frequencies. As a result, the amplitude and phase errors of the I/Q signal generator are significantly decreased in a wide frequency band. In addition, theoretical analysis based on a simplified equivalent-circuit model is performed to guide the circuit implementation, and its correctness is demonstrated by electromagnetic simulation. To mitigate the impact of the VGAs' parasitics on the phase performance, a capacitive-neutralization technique is applied to cancel parasitics of transistors in the VGAs. A prototype circuit is designed using a 130-nm SiGe BiCMOS process. The measured results show that the circuit achieves a root-mean-square (RMS) amplitude error of less than 1.4 dB and an RMS phase error of 1.4 degrees similar to 3.4 degrees across 18 similar to 32 GHz. The tested peak gains of all the phase states are -1 similar to 4.5 dB with an input balun (approximate to 1.9 dB loss) and an output balun (approximate to 2 dB loss) at 22 GHz. Also, the input 1-dB compression point and noise figure are tested, which are >=-1 dBm and <= 15.5 dB in the targeting frequency band.

A 32-38Ghz Full-360° Low-Phase-Error 6-Bit Passive Phase Shifter in 0.15μm GaAs

An E-band Subradix Active Phase Shifter with < 0.69° RMS Phase Error and 16-Db Attenuation in 28-Nm CMOS

An Ultra Broadband Passive Vector Modulator Phase Shifter

A C-Band Compact High-Linearity Multibeam Phased-Array Receiver With Merged Gain-Programmable Phase Shifter Technique

29-/35 GHz Dual-band High-Gain Phase Shifter with Hybrid -Networks

A Wideband 6-Bit Phase Shifter with Low RMS Error in 65nm CMOS Technology

A 26-32Ghz 6-Bit Bidirectional Passive Phase Shifter with 14dbm IP1dB and 2.6° RMS Phase Error for Phased Array System in 40nm CMOS

A Four-Element 7.5–9-Ghz Phased-Array Receiver with 1–8 Simultaneously Reconfigurable Beams in 65-Nm CMOS

An 18~30 GHz Vector-Sum Phase Shifter with Two-Stage Transformer-Based Hybrid in 130-Nm SiGe BiCMOS

An 18 similar to 30 GHz Vector-Sum Phase Shifter With Two-Stage Transformer-Based Hybrid in 130-nm SiGe BiCMOS

A 4-Element 7.5-9 GHz Phased Array Receiver with 8 Simultaneously Reconfigurable Beams in 65 Nm CMOS Technology

A 14-18Ghz 6bit Passive Phase Shifter in 0.13µm SiGe BiCMOS

A 23‐ to 28‐ghz 5‐bit Switch‐type Phase Shifter with 1‐bit Calibration Based on Optimized ABCD Matrix Design Methods for 5G MIMO System in 0.15‐μm GaAs

Ka-Band 4-Bit Phase Shifter With Low Phase Deviation

A 6-Bit CMOS Active Phase Shifter for Ku-Band Phased Arrays

A 6-Bit Phase Shifter with Low RMS Phase Error and Flat Gain Across 1.9–2.6Ghz

A 4-Bit CMOS Phase Shifter for Millimeter-Wave Phased Arrays

Design Of An X-Band 6-Bit Phase Shifter

A 27–31 ghz 6-Bit Phase Shifter with Low Phase Error/gain Variation in 65 nm CMOS

A 21 to 30-Ghz Merged Digital-Controlled High Resolution Phase Shifter-Programmable Gain Amplifier with Orthogonal Phase and Gain Control for 5-G Phase Array Application

A Wideband 6-Bit Phase Shifter MMIC for C-Band Application