Abstract:This article describes an ultra-high input-impedance active electrode (AE) circuit and the system to sense biopotential signals through a capacitively coupled interface. Various techniques from both circuit and system aspects are used to eliminate the input parasitic capacitance of the AE. On-chip parasitic capacitance is compensated by an auto-calibrated positive feedback loop (PFL) without applying any reference signal. A capacitor down-scaling technique combined with SAR-assisted PFL calibration enables femtofarad-level resolution of the capacitor array, alleviating the practical constraints of the conventional PFL to implement a small capacitor below 10 fF. Besides, a dummy input structure ensures that the pad and electrostatic discharge (ESD) capacitances are also canceled by the PFL, while off-chip parasitic capacitance on the printed circuit board (PCB) is nulled by active shielding. Fabricated in a standard 0.18- $\mu$ m 1P6M CMOS process, the AE achieves an ultra-high input impedance of 136 G $\Omega$ at 60 Hz (average of 10 samples). This is equivalent to an input capacitance of 19.5 fF and corresponds to a 2.7 $\times$ –68 $\times$ improvement over the state-of-the-art. The AE exhibits an input signal range of 700 mV $_{\mathrm{pp}}$ and an input-referred noise of 0.72 $\mu $ V $_{\mathrm{rms}}$ (0.5–100 Hz) while consuming 10.46 $\mu $ W from a 1.2-V supply. Each AE integrates an IC and a 3-cm $^{2}$ copper electrode on the PCB, and the wearable system prototypes successfully measured high-quality electrocardiogram (ECG) and electroencephalogram (EEG) signals from test subjects through capacitively coupled interfaces.

An Automated Impedance Enhancement Biopotential Recording Front-End Based on Mode Change Calibration Loop

A 2.1/5.2-NEF/PEF Capacitively Coupled Instrumentation Amplifier with Fast - Settling for Biosensor

A Novel High Input Impedance Front-End for Capacitive Biopotential Measurement

A low-noise CMOS front-end amplifier based on auto correction feedback for biomedical systems

A 3.6 Μw 60 Nv/sqrthz Capacitively-Coupled Instrumentation Amplifier for Biopotential Signal Recordings.

Design of an Analog Front-End for Ambulatory Biopotential Measurement Systems

A 20.3μw 1.9GΩ Input Impedance Capacitively-Coupled Chopper-Stabilized Amplifier for Bio-Potential Readout.

A 20.3$\mu $W 1.9G$\Omega $ Input Impedance Capacitively-Coupled Chopper-Stabilized Amplifier for Bio-Potential Readout

Ultra-High Input Impedance, Low Noise Integrated Amplifier for Noncontact Biopotential Sensing

A 35 nV/√Hz Analog Front-End Circuit with Adjustable Bandwidth and Gain in UMC 40 nm CMOS for Biopotential Signal Acquisition

A 100dB-TCMRR 8-Channel Bio-Potential Front-End with Multi-Channel Common-Mode Replication.

Common-Mode Noise Reduction in Noncontact Biopotential Acquisition Circuit Based on Imbalance Cancellation of Electrode-Body Impedance

An Auto-Zeroing Chopper-Stabilized Capacitively Coupled Instrumentation Amplifier with 25-Vpp Common-Mode Interference Tolerance

A 108 dB DR Δ∑-∑M Front-End With 720 mVpp Input Range and >±300 mV Offset Removal for Multi-Parameter Biopotential Recording.

Biopotential multi-path current feedback instrumentation amplifier with automatic offset cancellation loop for resistive bridge microsensors

Analog Front-End Input-Impedance Boosting Techniques for Bio-Potential Monitoring—A Review

An <tex>$8.73\mathrm{G}\Omega$</tex> Input Impedance VCO-Based Neural Front-End with Autonomous Time-Domain Impedance Boosting Technique and Maximum 0.215s Re-Calibration Time

A 15.5-ENOB 335 mV<sub>PP</sub>-Linear-Input-Range 4.7-G-Input-Impedance CT-M Analog Front-End With Embedded Low-Frequency Chopping

A 136-GΩ Input-Impedance Active Electrode for Non-Contact Biopotential Signals Monitoring

A TDM-based Analog Front-End for Ear-EEG Recording with 74.5-GΩ Input Impedance, 384-mV DC Tolerance and 0.27-μVrms Input-Referred Noise

An AC-Coupled Instrumentation Amplifier Achieving 110-Db CMRR at 50 Hz with Chopped Pseudoresistors and Successive-Approximation-Based Capacitor Trimming.