Abstract:Iron and steel industry is the pillar industry of the national economy, but it is also the source of highest carbon emission in manufacturing industry. With the proposal of China’s goal of peaking carbon emissions and achieving carbon neutrality, the steel industry urgently requires substantial technological breakthroughs in carbon reduction. About 90% of China’s crude steel production is produced through the blast furnace-basic oxygen furnace process, and blast furnace carbon consumption accounts for more than 70% of steel process carbon consumption. Therefore, blast furnace carbon reduction is the focal point of China’s steel industry’s efforts to mitigate carbon emissions. The hydrogen-rich gas injection to blast furnace and blast furnace with top gas recycling process are effective ways to reduce carbon emissions. However, these approaches still rely heavily on the fossil fuel coal-dominated energy structure. With the rapid development of renewable energy hydrogen production in China, hydrogen-rich oxygen blast furnace technology, which replaces carbon with hydrogen, can significantly reduce carbon emissions from ironmaking at the source. This article establishes a multizone constrained mathematical model for hydrogen-rich oxygen blast furnaces, calculates energy balance based on the constraint conditions of each zone, and systematically studies the influence of hydrogen injection, burden metallization rate on the coke ratio, top gas recycling injection volume, reducing gas composition, and CO2 emission reduction of hydrogen-rich oxygen blast furnaces. The research results show that at maximum hydrogen injection rate of about 600 N·m3 H2·t−1-HM (ton-hot metal), a replacement ratio of about 0.4 kg-coke·(N·m)−3-H2 was achieved with about 27% CO in the reduced gas of the shaft, 68% H2, 90% burden metallization rate. Coke ratio of the hydrogen-rich oxygen blast furnace is reduced to 203 kg and the CO2 emission is reduced to 501 kg·t−1-HM, 55% lower than that without hydrogen injection with a very significant CO2 reduction at the source.

Research on Limit Energy Consumption of Hydrogen-Rich Full Oxygen Blast Furnace

Heat distribution model under hydrogen-rich low-carbon conditions in blast furnace

Numerical Modeling and Analysis of Hydrogen Blast Furnace Ironmaking Process

Numerical Investigation of the Limit of Coke Rate Reduction in an Ironmaking Blast Furnace (BF)

Numerical Simulation Study of Co-injection of Pulverized Coal and Hydrogen in the Tuyere-Raceway

Numerical Study of the Reduction Process in an Oxygen Blast Furnace

Analysis of Carbon Emission Reduction Capacity of Hydrogen-Rich Oxygen Blast Furnace Based on Renewable Energy Hydrogen Production

Computational Study of Hot Gas Injection (HGI) into an Ironmaking Blast Furnace (BF)

Modeling on the Blast Furnace with CO2-enriched Hot Blast

Physicochemical principles of hydrogen metallurgy in blast furnace

Research on the impact of tuyere parameters on the states of hydrogen-rich blast furnace

Spectral Radiative Energy and Exergy Analysis of Oxy-Fuel Gaseous Media in One-Dimensional Furnace Cases

Numerical Study of Hydrogen-Rich Fuel Coherent Jet in Blast Furnace Tuyere

Numerical investigation of hydrogen-rich gas and pulverized coal injection in the raceway of a blast furnace with lower carbon emissions

Numerical Simulation and Analysis of Oxygen Blast Furnace under Different Injection Conditions

Particle-scale Modelling of Injected Hydrogen and Coke Co-Combustion in the Raceway of an Ironmaking Blast Furnace

Computational Fluid Dynamics Study of the Thermochemical Behaviors in an Ironmaking Blast Furnace with Oxygen Enrichment Operation

Modeling of the effect of hydrogen injection on blast furnace operation and carbon dioxide emissions

Use of Hydrogen–Rich Gas in Blast Furnace Ironmaking of V–bearing Titanomagnetite: Mass and Energy Balance Calculations

Numerical Investigation of Burden Distribution in Hydrogen Blast Furnace

Numerical Investigation of the Coupled Effect of H/D Ratio and Effective Volume on Optimized Blast Furnace Profile