Abstract:Iron and steel industry is the pillar industry of the national economy, but it is also the source of highest carbon emission in manufacturing industry. With the proposal of China’s goal of peaking carbon emissions and achieving carbon neutrality, the steel industry urgently requires substantial technological breakthroughs in carbon reduction. About 90% of China’s crude steel production is produced through the blast furnace-basic oxygen furnace process, and blast furnace carbon consumption accounts for more than 70% of steel process carbon consumption. Therefore, blast furnace carbon reduction is the focal point of China’s steel industry’s efforts to mitigate carbon emissions. The hydrogen-rich gas injection to blast furnace and blast furnace with top gas recycling process are effective ways to reduce carbon emissions. However, these approaches still rely heavily on the fossil fuel coal-dominated energy structure. With the rapid development of renewable energy hydrogen production in China, hydrogen-rich oxygen blast furnace technology, which replaces carbon with hydrogen, can significantly reduce carbon emissions from ironmaking at the source. This article establishes a multizone constrained mathematical model for hydrogen-rich oxygen blast furnaces, calculates energy balance based on the constraint conditions of each zone, and systematically studies the influence of hydrogen injection, burden metallization rate on the coke ratio, top gas recycling injection volume, reducing gas composition, and CO2 emission reduction of hydrogen-rich oxygen blast furnaces. The research results show that at maximum hydrogen injection rate of about 600 N·m3 H2·t−1-HM (ton-hot metal), a replacement ratio of about 0.4 kg-coke·(N·m)−3-H2 was achieved with about 27% CO in the reduced gas of the shaft, 68% H2, 90% burden metallization rate. Coke ratio of the hydrogen-rich oxygen blast furnace is reduced to 203 kg and the CO2 emission is reduced to 501 kg·t−1-HM, 55% lower than that without hydrogen injection with a very significant CO2 reduction at the source.

Modeling of the effect of hydrogen injection on blast furnace operation and carbon dioxide emissions

Numerical Simulation Study of Co-injection of Pulverized Coal and Hydrogen in the Tuyere-Raceway

Evaluation of Some Uncertainties in the Modeling of Blast Furnace Hydrogen Injection

Numerical Modeling and Analysis of Hydrogen Blast Furnace Ironmaking Process

CFD Study of Hydrogen Injection in Blast Furnaces: Tuyere Co-injection of Hydrogen and Coal

Numerical Investigation of Burden Distribution in Hydrogen Blast Furnace

Effects of hydrogen-rich fuel injection on the states of the raceway in blast furnace

Mathematical simulation and life cycle assessment of blast furnace operation with hydrogen injection under constant pulverized coal injection

A Numerical Study of Scenarios for the Substitution of Pulverized Coal Injection by Blast Furnace Gas Enriched by Hydrogen and Oxygen Aiming at a Reduction in CO2 Emissions in the Blast Furnace Process

CFD study of hydrogen co-injection through tuyere and shaft of an ironmaking blast furnace

Particle-scale Modelling of Injected Hydrogen and Coke Co-Combustion in the Raceway of an Ironmaking Blast Furnace

Heat distribution model under hydrogen-rich low-carbon conditions in blast furnace

Numerical Study of Hydrogen-Rich Fuel Coherent Jet in Blast Furnace Tuyere

Use of Hydrogen–Rich Gas in Blast Furnace Ironmaking of V–bearing Titanomagnetite: Mass and Energy Balance Calculations

Computational Study of Hot Gas Injection (HGI) into an Ironmaking Blast Furnace (BF)

Integrating a Top-Gas Recycling and CO2 Electrolysis Process for H2-Rich Gas Injection and Reduce CO2 Emissions from an Ironmaking Blast Furnace

The Influence of Hydrogen Injection on the Reduction Process in the Lower Part of the Blast Furnace: A Thermodynamic Study

Influence of Large Amount of Hydrogen Containing Gaseous Reductant Injection on Carbon Consumption and Operation Conditions of Blast Furnace - Development of Low Carbon Blast Furnace Operation Technology by using Experimental Blast Furnace: part II -

Numerical investigation of hydrogen-rich gas and pulverized coal injection in the raceway of a blast furnace with lower carbon emissions

Co-injection of hydrogen and biochar (CoHB) in a simulated blast furnace: A univariate and multivariate study

Analysis of Carbon Emission Reduction Capacity of Hydrogen-Rich Oxygen Blast Furnace Based on Renewable Energy Hydrogen Production