Abstract:There is a rapid progression toward spacecraft miniaturization due to the prospect of reduced launch costs, the requirement for satellite constellations, and the integration of microelectromechanical systems (MEMS). Satellite propulsion is required for increased mission flexibility and orbital debris mitigation, but down-scaling of such devices has proven non-trivial. Some electrostatic thrusters are both challenging and promising given their increase in performance with small geometry, but the relatively low thrust produced through ion acceleration limits their mission applicability. For this reason, it may be desirable to produce thrusters that are able operate across a wide range of specific impulses, depending on maneuver time, thrust bit requirements, and several other factors that influence propulsion system selection. At RAPPEL, a bimodal thruster that can operate at high specific impulse with electrospray propulsion or high thrust using cold gas expansion has been developed. Inevitably, such a propulsion system comes with complications related to performance characterization. A novel and economical data acquisition system has been established to measure the performance of both modes in high vacuum. For the cold gas mode, a torsional thrust balance was built in-house to measure thrust levels between 1 − 15 m N , and can be easily modified for lower ranges. The natural frequency of the thrust stand was measured to be 5.6 H z . The vacuum system sustained pressures below 5 m b a r while the cold gas nozzle operated, and 1.3 × 10 − 5 m b a r during electrospray operation. A 3-D printed linear cold gas nozzle was used to validate the thrust stand. Its thrust was close to 9 m N at a mass flow rate of 20 m g / s of nitrogen, producing a specific impulse of just under 45 s . Due to the noise present in thrust stand measurements at the sub- m N force-level produced by electrosprays, the thrust stand was built to also accommodate a complementary ion beam current measurement system. The power processing unit, used to generate square-wave ± 2500 V signals using optodiodes, was built to operate a bipolar ionic liquid ion source (ILIS). The rise and fall times of the push/pull switch were close to 1 m s and 30 m s , respectively. The electrical power system used to operate the electrospray and measure its performance is examined in detail, followed by the results from validation of both data acquisition systems.

Direct Thrust Measurement of Compact Hexapole ECR Thruster

Compact Permanent Magnet Hexapole ECR Ion Thruster

Design of Compact Hexapole ECR Ion Thruster

Electron Trajectory Simulation in Compact Hexapole ECR Ion Thruster

Direct Thrust Measurement of an Electron Cyclotron Resonance Plasma Thruster

Thrust measurements of a waveguide electron cyclotron resonance thruster

Optimization of a coaxial electron cyclotron resonance plasma thruster with an analytical model

Magnetic Confinement Less Microwave Discharge Gridded Ion Thruster

Development of a microthrust balance and ion beam measurement system: Characterizing a dual-mode thruster for spacecraft

Study on the Ionization and Acceleration of a Microwave Discharge Cusped Field Thruster

Electron Cyclotron Resonance Discharge Enhancement in a Cusped Field Thruster

Axial Magnetic Field Effect on Vacuum Arc Thruster Performance

Thrust Enhancement of a Microwave Ion Thruster

A New Concept of Using Chemical Energy to Improve the Efficiency of the ECR Magnetic Nozzle Thruster

Experimental investigation of the electromagnetic acceleration mechanisms in an Applied-field Magnetoplasmadynamic Thruster

Investigation on the Radial Distribution of Electron Density in a Miniaturized ECR Ion Thruster of Wide-Range Operations

A Xenon Collisional-Radiative Model Applicable to Electric Propulsion Devices: II. Kinetics of the 6s, 6p, and 5d States of Atoms and Ions in Hall Thrusters

Design of Magnetically Enhanced Hollow Cathode Micro-Thruster: Concept and Experimental Research

A Minimized Electron Cyclotron Resonance Ion Thruster for China's Space-Borne Gravitational Wave Detection Missions

Comparing Direct and Indirect Thrust Measurements from Passively Fed Ionic Electrospray Thrusters

Development of a cantilever beam thrust stand for electric propulsion thrusters