Abstract:There is a rapid progression toward spacecraft miniaturization due to the prospect of reduced launch costs, the requirement for satellite constellations, and the integration of microelectromechanical systems (MEMS). Satellite propulsion is required for increased mission flexibility and orbital debris mitigation, but down-scaling of such devices has proven non-trivial. Some electrostatic thrusters are both challenging and promising given their increase in performance with small geometry, but the relatively low thrust produced through ion acceleration limits their mission applicability. For this reason, it may be desirable to produce thrusters that are able operate across a wide range of specific impulses, depending on maneuver time, thrust bit requirements, and several other factors that influence propulsion system selection. At RAPPEL, a bimodal thruster that can operate at high specific impulse with electrospray propulsion or high thrust using cold gas expansion has been developed. Inevitably, such a propulsion system comes with complications related to performance characterization. A novel and economical data acquisition system has been established to measure the performance of both modes in high vacuum. For the cold gas mode, a torsional thrust balance was built in-house to measure thrust levels between 1 − 15 m N , and can be easily modified for lower ranges. The natural frequency of the thrust stand was measured to be 5.6 H z . The vacuum system sustained pressures below 5 m b a r while the cold gas nozzle operated, and 1.3 × 10 − 5 m b a r during electrospray operation. A 3-D printed linear cold gas nozzle was used to validate the thrust stand. Its thrust was close to 9 m N at a mass flow rate of 20 m g / s of nitrogen, producing a specific impulse of just under 45 s . Due to the noise present in thrust stand measurements at the sub- m N force-level produced by electrosprays, the thrust stand was built to also accommodate a complementary ion beam current measurement system. The power processing unit, used to generate square-wave ± 2500 V signals using optodiodes, was built to operate a bipolar ionic liquid ion source (ILIS). The rise and fall times of the push/pull switch were close to 1 m s and 30 m s , respectively. The electrical power system used to operate the electrospray and measure its performance is examined in detail, followed by the results from validation of both data acquisition systems.

Direct Thrust Measurement of an Electron Cyclotron Resonance Plasma Thruster

Thrust measurements of a waveguide electron cyclotron resonance thruster

Thrust measurement of an ion thruster by a force probe approach and comparison to a thrust balance

Direct Thrust Measurement of Compact Hexapole ECR Thruster

Thrust Enhancement of a Microwave Ion Thruster

Comparing Direct and Indirect Thrust Measurements from Passively Fed Ionic Electrospray Thrusters

Development of a microthrust balance and ion beam measurement system: Characterizing a dual-mode thruster for spacecraft

Optimization of a coaxial electron cyclotron resonance plasma thruster with an analytical model

Plume Composition Measurements of a High-Emission-Density Electrospray Thruster

Investigation of the directional Faraday cup and improvement of the comparison between direct and indirect thrust measurements of a magnetic nozzle ECR thruster

Incoherent Thomson scattering measurements of electron properties in a conventional and magnetically-shielded Hall thruster

A study of an air-breathing electrodeless plasma thruster discharge

Experimental research on micro thrust measurement of ion thruster under variable working conditions

Thrust stand based on a single point load cell for impulse measurements from plasma thrusters

Experimental investigation of the electromagnetic acceleration mechanisms in an Applied-field Magnetoplasmadynamic Thruster

Ion beam diagnostic for the assessment of miniaturized electric propulsion systems

Impulse and Performance Measurements of Electric Solid Propellant in a Laboratory Electrothermal Ablation-Fed Pulsed Plasma Thruster

An impulsive thrust balance for applications of micro-pulsed plasma thrusters

0-D composition and performance analysis of an air-breathing radiofrequency ion thruster

Charge Neutralization and Direct Thrust Measurements from Bipolar Pairs of Ionic Electrospray Thrusters

3D ion velocity distribution function measurement in an electric thruster using laser induced fluorescence tomography