Abstract:In transport of raw materials abrasive wear resistance is a requirement, which can be met with alumina ceramics. At certain locations additional impact load occurs, exacerbating the wear loss. As literature on impact-abrasive wear of ceramics is scarce this topic will be researched in this work. We selected a variety of commercial alumina ceramics (90-96% Al 2 O 3 ) and according to literature much more impact resistant – and substantially more expensive – Zirconia Toughened Alumina (ZTA, 20-25% Zr) used for wear resistant linings in impact dominated systems. We selected the Impeller-Tumbler test, an impact-abrasion test for wear evaluation of highly loaded ceramic edges. Two load regimes were evaluated for the abrasive, either corundum particles for severe load or steel for extreme load conditions. Correlation of wear results with the fracture toughness (K 1C ) and Vickers hardness of the materials is intended – material parameters used as measure for brittle failure of ceramics and wear resistance, respectively. The various ceramic materials showed very different wear behaviour under the impact-abrasive load. The 90% Al 2 O 3 was least wear resistant under both load conditions. Interestingly large differences between the 92% types were found at extreme load conditions. The increase of alumina content to 95-96% showed remarkable benefits in both wear regimes. Best wear resistance against severe load was achieved by 25% ZTA, while it is comparable to the 95-96% high alumina types at extreme load.

Slurry Erosive Wear Characteristics of Engineering Ceramics for Hydraulic Machinery

Erosive Wear Performance and Mechanism of Engineering Ceramic Materials

Study on Erosive Wear and Novel Wear-Resistant Materials for Centrifugal Slurry Pumps

Study on the erosion wear characteristics and mechanisms of UBHMWPE/kaolin composites

Study on the erosive wear behavior of Al2O3 ceramics

Study on Erosion Resistance of Structural Ceramics

Erosion-Wear Property of α-Al2O3 Structure Ceramics with Different Experiment Parameters

Effect of Different Abrasive Particle Hardness on Erosion Resistant Performance of ZTA Structure Ceramics

Effect of Different Abrasive Particle Hardness on the Erosion Resistant Performance of Α-Al<sub>2</sub>o<sub>3</sub> Ceramics

Preparation of Ultra-Fine ATC Ceramics and Analysis of Its Dry-Sliding Wear Behavior

Wear performance of alumina-based ceramics - a review of the influence of microstructure on erosive wear

Interfacial characterization and erosive wear performance of zirconia toughened alumina ceramics particles reinforced high chromium white cast irons composites

Effect of Different Abrasive Particle Hardness on the Erosion Resistant Performance of α-Al<sub>2</sub>O<sub>3</sub> Ceramics

Effect Of Impact Angle On The Resistant-Erosion Performance Of Zta Ceramics

Effect of different abrasive particle hardness on the erosion resistant performance of α-Al2O3 ceramics

Impact-abrasive wear resistance of high alumina ceramics and ZTA

The relation of mechanical properties and resistance erosion-wear of structure ceramic

Erosion Wear Characteristics and Mechanism of Si<sub>3</sub>N<sub>4</sub> Ceramics: Effect of Impact Angle

Abrasive Erosion Comparison for A Ceramics and A High Chrome Cast Iron Applied in A Slurry Pump

Erosion wear characteristics and mechanism of Si3N4 ceramics: Effect of impact angle