Abstract:The accurate determination of fracture toughness of fiber-reinforced composites is critical for the assessment of structural integrity. Although there have been many studies on the intralaminar fracture behavior of composites, satisfactory results have not yet been obtained regarding the influence of specimen types. In this paper, commonly used fracture specimens (DCT, CT, ESET, pin-loaded SENT and clamped SENT specimen) are applied to study their applicability in the fracture behaviors of composites with different orientations. And the impact of data processing methods for the area method, G C -compliance and G C -stress intensity factors on fracture performance was analyzed. The results showed that the above three data processing methods have obtained relatively consistent fracture properties. Different specimens obtained significantly various results, showing a gradually decreasing trend from clamped SENT, ESET, pin-loaded SENT, CT to DCT. Furthermore, considering that the clamped SENT specimen is closest to the Mode-I fracture toughness obtained from the DCB specimen, and there is no compression damage in the experiments under different orientations, this specimen type is the most recommended specimen. Finally, the failure mechanisms of carbon fiber-reinforced composite under different specimen types and orientations were revealed. As the orientation angle increases ( β from 0° to 90°), the failure mode gradually transitions from matrix cracking and interface debonding to matrix shear and fiber fracture. The above achievements will contribute to a deeper understanding of the intralaminar fracture process and failure mechanism of fiber-reinforced composites.

Using Spiral Notch Torsional Test to Investigate Fracture of Unidirectional Fiber Reinforced Composites

Investigating Fracture Behaviors of Polymer and Polymeric Composite Materials Using Spiral Notch Torsion Test

Study on Fracture of Fiber-Reinforced Polymeric Composites Using Spiral Notch Torsion Test

An Experimental Study on the Fracture of a Unidirectional Carbon Fiber-Reinforced Composite under Quasistatic Torsion

Spiral Notch Torsion Test Use for Determining Fracture Toughness of Structural Materials

A New Approach to Evaluate Fracture Toughness of Structural Materials

Nonlinear Fracture Analysis of Delamination Crack Jumps in Laminated Composites

Analysis of the Effect of Fiber Orientation on Mechanical and Elastic Characteristics at Axial Stresses of GFRP Used in Wind Turbine Blades

Exploring the influence of specimen types on the intralaminar fracture behavior of fiber-reinforced polymer matrix composites

Experimental Studies on Fracture of Unidirectional Glass-Fibre-Reinforced Plastics Composites with V-Notch

Mixed-Mode Interlaminar Fracture Toughness of Glass and Carbon Fibre Powder Epoxy Composites—For Design of Wind and Tidal Turbine Blades

Mechanical response and critical failure mechanism characterization of notched carbon fiber reinforced polymer laminate subjected to tensile loading

In Situ Damage Propagation and Fracture in Notched Cross-Ply SiC/SiC Composites: Experiment and Numerical Modeling

Notch effect in tension-tension fatigue of short glass fibre reinforced polyphenylene sulfide composites

X-ray computed tomography study of compressive failure in a notched unidirectional glass fiber-reinforced composites

Real-Time Observation of Damage Nucleation in Three-Dimensionally Reinforced Carbon/Carbon Composites and Role of Bundle/Matrix Interface

Notch insensitivity in fatigue failure of chopped carbon fiber chip-reinforced composites using experimental and computational analysis

Experimental investigation of CNT effect on curved beam strength and interlaminar fracture toughness of CFRP laminates

Revisiting the Structural Collapse of A 52.3 M Composite Wind Turbine Blade in A Full-Scale Bending Test

Bridging Mechanisms in a Tiβ21s/SCS-6 Composite: In-Situ Scanning Electron Microscopy Study

A Modified Anti-Symmetric Four-Point Bending Method for Testing C/C Composites under Biaxial Shear and Compression