Abstract:Permanent magnet vernier machines (PMVMs) exhibit the feature of high torque density, which makes them a compelling candidate for gearless direct-drive applications, such as electric vehicle (EV) and servo drive. However, the motor suffers from low power factor issue. And the long end winding, caused by overlaps and long spanning distance, significantly reduces the efficiency and torque density for motors with small size and short stack length. This paper investigates the performance metrics of PMVMs with surface Halbach magnet array for different slot/pole combinations (gear ratios) and winding layouts (short-pitch, fractional-slot). It is found that the fractional-slot winding creates more possibility for vernier machines. First, the working principle of vernier machines is analyzed and the performance metrics are modeled with analytical approach. Then, the motor configuration is classified according to winding layout and some promising structures are selected. Later, a comprehensive comparison is conducted for selected candidates in all electromagnetic performance by using finite element analysis (FEA). The results show that the vernier motors with fractionalslot winding layout and non-integer gear ratios can achieve much lower torque ripple, and higher power factor than integral-slot winding, while sacrifising a little active torque density. Designs with smaller gear ratios can achieve higher efficiency due to short end winding. These findings can provide design guidelines for high-performance PMVMs.

Torque and Loss Analysis of Permanent Magnet Vernier In-Wheel Motors with Rotor Flux Barriers

Analytical Sub-Domain Model for Predicting Open-Circuit Field of Permanent Magnet Vernier Machine Accounting for Tooth Tips

Analytical investigation of open-circuit eddy current loss in windings of PM machines

Influence of Rotor Configuration on Iron and Magnet Losses of Fractional-Slot IPM Machines

Investigation of Short Permanent Magnet and Stator Flux Bridge Effects on Cogging Torque Mitigation in FSPM Machines

Analytical On-Load Subdomain Field Model of Permanent-Magnet Vernier Machines.

Design and Analysis of Outer Rotor Permanent-Magnet Vernier Machines with Overhang Structure for In-Wheel Direct-Drive Application

Comparison of Direct-Drive Permanent-Magnet Synchronous Motor and Permanent-Magnet Flux-Modulated Motor for Electric Vehicles

Design and Analysis of a Novel Dual-PM Flux Reversal Machine for Electric Vehicle Propulsion

Analysis of Dual PM Vernier Machines with Different Consequent-Pole PM Topologies

Comparison of PMSMs with Different Rotor Structures for EV Application

Design Considerations, Analysis and Comparison for High-performance Surface Permanent Magnet Vernier Machines

Dynamic Reluctance Mesh Modeling and Losses Evaluation of Permanent Magnet Traction Motor

Analysis of a High-Torque PM Vernier Motor with Thick Embedded Permanent Magnets using the Frozen Permeability Method

Comparison and Analysis of Permanent Magnet Vernier Motors for Low‐noise In‐wheel Motor Application

Performance Comparison Between Permanent Magnet Synchronous Motor and Vernier Motor for In-Wheel Direct Drive

Analytical Modeling of Eddy Current Losses and Thermal Analysis of Non-Uniform-Air-Gap Combined-Pole Permanent Magnet Motors for Electric Vehicles

Design and Analysis of a New Hybrid Excitation Vernier Motor with Reduced Permanent Magnet

Design and analysis of a hybrid permanent magnet variable leakage flux motor for low core loss and wide speed range

3-D analysis of eddy current losses in permanent PMSM magnets

Design and performance analysis of a novel flux-concentrating fault tolerant permanent magnet vernier machine for rim driven thruster