Abstract:Removing the gearbox from the single-motor configuration of an electric vehicle (EV) would improve motor-to-wheel efficiency by preventing mechanical losses, thus extending the autonomy of the EV. To this end, a permanent-magnet Vernier machine (PMVM) is designed to ensure such operation. This machine avoids the high volume and large pole-pair number of the armature winding since its operating principle resembles that of a synchronous machine with an integrated magnetic gear. Therefore, such a structure achieves low-speed and high-torque operation at standard supply frequencies. From the specification of an urban vehicle, the required specification for direct-drive operation is first determined. On this basis, an initial prototype of a Vernier Machine with permanent magnets in the rotor that can replace the traction part (motor + gearbox) is designed and sized. This first prototype uses radial contiguous surface-mounted magnets and its performance is then analyzed using finite element analysis (FEA), showing a relatively high torque ripple ratio. The rotor magnets are then arranged in a quasi-Halbach configuration and simulations are performed with different stator slot openings and different ratios of the tangential part of the magnet in order to quantify the effect of each of these two quantities in terms of average torque, torque ripples and harmonics of the back-electromotive force at no load. Since the design and optimization of this motor is finite element-assisted, a coupling process between FEA Flux software and Altair HyperStudy is implemented for optimization. This method has the advantages of high accuracy of the magnetic flux densities and electromagnetic torque estimates, and especially the torque ripples. The optimization process leads to a prototype with an average torque value that meets the specification, along with a torque ripple ratio below 5% and a high power factor, while keeping the same amount of magnet and copper.

Design Considerations, Analysis and Comparison for High-performance Surface Permanent Magnet Vernier Machines

Comparison of Optimal Design and Performance of PM Machines Having Non-Overlapping Windings and Different Rotor Topologies

Analytical Sub-Domain Model for Predicting Open-Circuit Field of Permanent Magnet Vernier Machine Accounting for Tooth Tips

Analytical On-Load Subdomain Field Model of Permanent-Magnet Vernier Machines.

Analytical Modeling of Surface-Mounted PM Machines Accounting for Magnet Shaping and Varied Magnet Property Distribution

Design Criterion and Analysis of Hybrid-Excited Vernier Reluctance Linear Machine with Slot Halbach PM Arrays

Influence of Split Teeth on the Performance of Linear Permanent Magnet Vernier Motor

Design and Analysis of Outer Rotor Permanent-Magnet Vernier Machines with Overhang Structure for In-Wheel Direct-Drive Application

Design of a Chamfered Structure on Consequent-Pole Vernier Permanent-Magnet Machine

Analysis of Dual PM Vernier Machines with Different Consequent-Pole PM Topologies

Design Consideration of Fractional Slot Concentrated Winding Interior Permanent Magnet Synchronous Motor for EV and HEV Applications

Research on the Influence of End Turn Length on Consequent-Pole Vernier Permanent-Magnet Machines

Analytical Model of Electromagnetic Performance for Permanent-Magnet Vernier Machines Using Nonlinear Exact Conformal Model

Design of Quasi-Halbach Permanent-Magnet Vernier Machine for Direct-Drive Urban Vehicle Application

Analytical Modeling of A Novel Vernier Pseudo-Direct-Drive Permanent-Magnet Machine

Design and Analysis of a New Hybrid Excitation Vernier Motor with Reduced Permanent Magnet

Comparisons of Permanent-Magnet Machines with Different Rotor Topologies for Quadruped Robot

Design and Analysis of a 500W 120000rpm High-Speed Permanent Magnet Motor

Comparative Analysis and Design Optimization of Ferrite-Based Surface PM Vernier Machines

Design and Analysis of Novel Modular Stator Axial-Flux Permanent Magnet Vernier Machine With Improved Power Factor

Comparative Analysis of Doubly Fed Flux-Reversal Permanent Magnet Machines with Different PM Arrangements and Consequent-Pole Topologies