Abstract:The intermittent connection(IC) of the field-bus in networked manufacturing systems is a common but hard troubleshooting network problem, which may result in system level failures or safety issues. However, there is no online IC location identification method available to detect and locate the position of the problem. To tackle this problem, a novel model based online fault location identification method for localized IC problem is proposed. First, the error event patterns are identified and classified according to different node sources in each error frame. Then generalized zero inflated Poisson process(GZIP) model for each node is established by using time stamped error event sequence. Finally, the location of the IC fault is determined by testing whether the parameters of the fitted stochastic model is statistically significant or not using the confident intervals of the estimated parameters. To illustrate the proposed method, case studies are conducted on a 3-node controller area network(CAN) test-bed, in which IC induced faults are imposed on a network drop cable using computer controlled on-off switches. The experimental results show the parameters of the GZIP model for the problematic node are statistically significant(larger than 0), and the patterns of the confident intervals of the estimated parameters are directly linked to the problematic node, which agrees with the experimental setup. The proposed online IC location identification method can successfully identify the location of the drop cable on which IC faults occurs on the CAN network.

Comparison Study of Error Patterns of Intermittent Open and Short Circuit Connection Faults in CAN Network

Tree-Based Intermittent Connection Fault Diagnosis for Controller Area Network

Design and Test of Hardware-in-the-loop Platform for Vehicle Chassis CAN System with Intermittent Open and Short Connection Faults

Intermittent Short Circuit Fault Location for CAN Based on Two-Port Network Modeling

Diagnosis of Intermittent Connection Faults for CAN Networks With Complex Topology

Association Model-Based Intermittent Connection Fault Diagnosis for Controller Area Networks

Fault Location for the Intermittent Connection Problems on CAN Networks

Data-driven Method in Detecting CAN Network Intermittent Connection Fault

Physical Layer Identification of Intermittent Open and Short Connection Faults in CAN Network

Intermittent Connection Fault Diagnosis for CAN Using Data Link Layer Information.

Availability evaluation of controller area networks under the influence of intermittent connection faults

Message response time distribution analysis for Controller Area Network containing errors

Experimental Study On The Intermittent Connection Problems On Can Network

Fault location identification for localized intermittent connection problems on CAN networks

Voltage-Based Physical Layer Fault Diagnosis for Controller Area Network

Data driven root cause analysis for intermittent connection faults in controller area networks

Controller Area Network Bus Physical Faults and Redundancy

Modeling for Early Fault Detection of Intermittent Connections on Controller Area Networks

Deep Learning-Based Fault Diagnosis for CAN Bus

Reliability Analysis of CAN nodes under Electromagnetic Interference

Message delay time distribution analysis for controller area network under errors