Abstract:A grid-forming (GFM) inverter can effectively support active power and reactive power, and the stability problem induced by the low inertia can be thereby alleviated in a power electronics-dominated power system. Yet, the voltage source characteristic presented by the grid-forming inverter induces an overcurrent problem during a short-circuit fault. Furthermore, the time delay induces an inrush current in traditional digital control, triggered by a predefined timing sequence. To address the overcurrent problem of the GFM inverter controlled by the digital controller, the operation characteristics of GFM inverters under grid-voltage drops are investigated, and a mathematical model of the instantaneous fault current is established, which depicts the relationship between the instantaneous fault current's magnitude, grid-voltage drop severity, equivalent output impedance, and current inner-loop response speed. Then, a Set–Reset (SR) latch-based dynamic current limitation with event-triggered control is proposed for the low-voltage ride-through of the GFM inverter. In the proposed method, the current limitation is enabled during grid fault, and the active and reactive powers can be recovered rapidly after fault clearance. Meanwhile, the active and reactive power references are designed to enhance synchronization stability during the grid fault. The proposed method addresses the issue of the repeated switching of virtual impedance during grid fault and achieves rapid power recovery after fault clearance. In addition, the proposed method uses the logic of event triggers to respond to the overcurrent event in real time and realize overcurrent protection. The simulation and experimental results demonstrate the effectiveness of the proposed method in current limitation and active-power recovery after fault clearance.

Adaptive-Output-Voltage-Regulation-Based Solution for the DC-Link Undervoltage of Grid-Forming Inverters

A Low-Voltage Ride-Through Control Strategy for Three-Phase Grid-Connected Pv Systems

Instantaneous Voltage Regulated Seamless Transfer Control Strategy for Utility-interconnected Fuel Cell Inverters with an LCL-filter

Flexible Control of DC-link Voltage for Doubly Fed Induction Generator During Grid Voltage Swell

Dc-Voltage Fluctuation Elimination Through A Dc-Capacitor Current Control for Dfig Converters under Unbalanced Grid Voltage Conditions

Optimal DC Voltage and Current Control of an LCC HVDC System to Improve Real-Time Frequency Regulation in Rectifier- and Inverter-Side Grids

An Adaptive Current-Limiting Strategy for Grid-Forming Converters under Grid Faults

Adaptive low voltage crossing strategy for symmetrical faults of networked inverters

A Strong-Grid-Friendly Voltage Control Method of Grid-Forming Inverters

A Flexible Saturation Limiter for DC-Link Voltage Control of Grid-Forming Inverters with Enhanced Transient Stability

Full Grid Voltage Feedforward for Critical Mode LCL-Type Single-Phase Grid-Tied Inverters With Physical Interpretations

Multiple Loops of Current-Limiting Control for Grid-forming Inverters in the Overload Conditions

An Adaptive Virtual-Impedance-Based Current-Limiting Method with the Functionality of Transient Stability Enhancement for Grid-Forming Converter

A Generic Voltage Control for Grid-Forming Converters With Improved Power Loop Dynamics

Design-Oriented Analysis of DC-Link Voltage Control for Transient Stability of Grid-Forming Inverters

Dynamic Current-Limitation Strategy of Grid-Forming Inverters Based on SR Latches

A Multi-Objective Control Strategy for Three Phase Grid-Connected Inverter During Unbalanced Voltage Sag

An Extension of Grid-Forming: A Frequency-Following Voltage-Forming Inverter

Low voltage ride through control strategy for high-power grid-connected photovoltaic inverter

A Stability Enhancement Method Based on Adaptive Virtual Resistor for Electric-hydrogen Hybrid DC Microgrid Grid-connected Inverter Under Weak Grid