Abstract:An accurate description of the electromagnetic properties of materials is fundamental to optical and electric devices. As a current research hotspot, thin slabs generally are modeled as a film of finite thickness with a dielectric function. However, inspired by two-dimensional materials, thin slabs can be regarded as surface current sheets with conductivity. Due to the convenience of the latter in simplifying the calculations, it becomes increasingly significant to determine the equivalent conditions of the two models. In this work, we compare the differences between the thin film and surface current models in calculating the transmissivity, reflectivity, and absorptivity of a SiC film. For normal incidence, the difference between the calculations of the two models is only non-negligible when the thickness is large (500 nm), because of the invalidation of surface current models and the excitation of Fabry-Perot resonance. In particular, we derive analytical formulas for the relative error in transmittance versus phase difference, which can be used to predict the difference between the two models as a function of film thickness. For oblique incidence, the two models have significant differences in the vicinity of epsilon-near-zero (ENZ) frequency. The excitation of the Berreman leaky mode in a thin film model causes a narrow blank absorption peak close to the ENZ frequency. However, we found that the surface current model is unable to form this resonance mode and further demonstrate it theoretically. In addition, it is found that the two models are equivalent in the case of a transverse electric wave even though the incidence is oblique. This work can enhance the awareness of the light-matter interaction and open unprecedented avenues for designing ultrathin optical devices.

How to Determine the Spectral Properties of a 3-Nm Thin Film?

Broad-Band Attenuated Total Reflection Spectroscopy of a Hydrated Protein Film on a Single Mode Planar Waveguide

A fully automatized method for the unambiguous wavelength-by-wavelength determination of the thickness and optical property of a very thin film with a transparent range

Fourier-transform Spectrometer Chip Covering Visible Band on Silica Planar Waveguide

Investigating Ultra-thin Ag and Au Layers Using Spectrophotometry and AFM Imaging

Thickness Mapping and Layer Number Identification of Exfoliated van der Waals Materials by Fourier Imaging Micro-Ellipsometry

Optical weak measurement for the precise thickness determination of an ultra-thin film

Comprehensive investigation on chalcogenide thin film coated multimode optical fiber: Visible evanescent-wave absorption refractometer

Optical-Properties of Extremely Thin-Films - Studies Using Atr Techniques

Single Nanoparticle-Based Heteronanojunction As a Plasmon Ruler for Measuring Dielectric Thin Films.

A Review of Thin-film Thickness Measurements using Optical Methods

Optical and Structural Properties of Ultra-thin Gold Films

Thickness-Dependent Raman Scattering from Thin-Film Systems

A new method to measure spectral reflectance and film thickness using a modified chromatic confocal sensor

Characterization of highly anisotropic three-dimensionally nanostructured surfaces

A comprehensive optical analysis of nanoscale structures: from thin films to asymmetric nanocavities

Nanoscale-resolved chemical identification of thin organic films using infrared near-field spectroscopy and standard Fourier transform infrared references

Comparative analysis of two models for the optical response of a thin slab: a film of finite thickness versus a surface current sheet

Determining the refractive index, absolute thickness and local slope of a thin transparent film using multi-wavelength and multi-incident-angle interference

Lossy mode resonance sensors based on lateral light incidence in nanocoated planar waveguides