Abstract:The IGZO (InGaZnO)-based two-transistor zero-capacitor(2T0C) DRAM has attracted much attention as an alternative memory to overcome the scale-down limit of current 1T1C DRAM due to its low power consumption and monolithic 3D stacking capability. In particular, its low power consumption and the feasibility of low temperature process make it highly implementable for 3D DRAM. For operating the 2T0C DRAM, four metal lines are necessary, i.e., write word line and write bit line (WBL) for operating write transistor (WTR), and read word line and read bit line (RBL) for operating read transistor (RTR). In this study, we propose a 3-terminal 2T0C DRAM to enhance its memory characteristics, where RBL was combined with WBL, enabling 2T0C memory operation with only three metal lines as shown in Fig. 1(b). In addition, we investigated the dependency of retenetion time of the proposed 2T0C DRAM on channel length. In particular we evaluated the dependency of the sneak current of 2T0C DRAM on off-current of transistor. For the fabrication of 3-terminal IGZO 2T0C DRAM, a top gate IGZO transistor was fabricated using RF sputtering and two transistors were connected by storage node and bit line bridge as shown in Fig. 1(d).The storage node was formed by connecting the gate of RTR to drain of WTR. And source electrodes of both transistors were coupled. To determine the voltage values for memory operation, the transfer curve of each transistor was characterized and the threshold voltages for both RTR and WTR were around 1 V. The write and read voltages were set to 3 and 2 V, respectively. The retention time was measured by performing periodic read operations after writing and measuring the RTR currents. In addition, the retention time of transistors for varying channel length and gate capacitance was characterized. The retention time was defined as the time to be taken for decreasing the currents by 90 %. Furthermore, the disturbance of 2T0C DRAM with 2x2 array structure was investigated. The RTR currents of selected cells were measured depending on the memory state of adjacent cells. It was found that the retention times of transistors with 10- and 100-um RTR channel lengths were approximately 15 and 30 seconds, respectively. It was observed that the memory state was not changed from “0“ to “1“ by disturbant currents, but, RTR currents of “0“ state cell increased slightly when an adjacent cell was turned on. However, as shown in Fig.1(i) and (j), when off-currents of transistor of 2T0C DRAM decreased from 20 nA to 200 pA, it was confirmed the sneak current of 2T0C decreased. Finally, several technical apporaches how to suppress the disturbant currents will be presented in detail. Acknowledgement This research was supported by BrainKorea21 Four. Figure 1

Novel 2T DRAM by Storing Data in One Alternative Gate of a Double-Gate Transistor with a Low-leakage Oxide Transistor

Computational Associative Memory with Amorphous Metal‐Oxide Channel 3D NAND‐Compatible Floating‐Gate Transistors

Cell Structure and Process Integration of a Novel 2T0C Technology for High-Density Dram Application

A Novel Capacitorless 1T DRAM with Embedded Oxide Layer

The Programming Optimization of Capacitorless 1T DRAM Based on the Dual-Gate TFET

Novel 2T gain cell with enhanced retention time for embedded DRAM application

A 2T Dual Port Capacitor-Less DRAM

Improved Multi-bit Statistics of Novel Dual-gate IGZO 2T0C DRAM with In-cell VTH Compensation and ΔVSN/ΔVDATA Boosting Technique

Capacitorless DRAM Cells Based on High-Performance Indium-Tin-Oxide Transistors with Record Data Retention and Reduced Write Latency

3-Terminal Igzo FET Based 2T0C DRAM Combined Bit-Line Structure

A Non-Volatile AND Gate Based on Al2O3/HfO2/Al2O3 Charge-Trap Stack for In-Situ Storage Applications

Floating Dynamic Access Technology

3D-Stacked 2T0C-DRAM Cells Using Al2O3/TiO2-Based 2DEG FETs

Vertical Surrounding Gate Transistor for High Density and Low Voltage Operation in DRAM

Design of a Novel One Transistor-Dram Based on Bulk Silicon Substrate

Progress in Z(2)-Fet 1T-Dram: Retention Time, Writing Modes, Selective Array Operation, and Dual Bit Storage

Organic Nonvolatile 2T Memory Cell Employing a NOT‐Gate‐Like Architecture Toward Binary Output Level With Enhanced Noise Tolerance

A Semi-Floating Gate Memory with Tensile Stress for Enhanced Performance

A Novel 1T-1D DRAM Cell for Embedded Application

A 3-Transistor DRAM Cell with Gated Diode for Enhanced Speed and Retention Time

Novel Vertical Channel Double Gate Structures for High Density and Low Power Flash Memory Applications.