Abstract:Especially in the electric vehicle industry where both high energy density and long lifetime batteries are sought, Ni-based cathode materials such as LiNi 1−x−y Mn x Co y O 2 (NMC) and LiNi 1−x−y Co x Al y O 2 (NCA) provide a fitting compromise in capacity and cyclability. In recent years, the high cost of cobalt in addition to the problematic geopolitics surrounding cobalt mining have motivated research efforts toward cobalt-free cathode materials. 1 However, Ni-rich materials are subject to inevitable failure mechanisms such as microcracking and parasitic reactions with the electrolyte which are further aggravated with an increase in Ni-content and in the absence of Co. 2 Many strategies have been proposed to overcome these challenges such as doping and/or coating the cathode particles, 3 but there remains a need to further increase energy density with minimal compromise to lifetime. In this work we present a cathode active material system designed to push Ni-rich and Co-free materials to the limit of their performance. This is done by choosing optimal polycrystalline particle size, a balance of Mn and Al content, and a sufficient amount of high-valence doping. Additionally, appropriate synthesis conditions are needed to obtain the desired morphology and infuse the intergranular boundaries with the W dopant. It is then important to choose an appropriate upper cutoff voltage during cycling to maximize energy while avoiding drastic crystal changes. 4 This optimized NMA-W material system delivers specific capacity above 200 mAh/g while retaining 95% of its capacity without relying on any amount of Co. The series of NMA-W materials presented in this work were characterized and tested. Scanning electron microscopy (SEM) images were used to observe morphology and crystallite growth after synthesis. X-ray diffraction (XRD) analysis was conducted to monitor the crystal parameters and accelerated rate calorimetry (ARC) was used to assess the thermal stability and safety of the material. Compression tests were also conducted to study the strength of the particles and their propensity to crack under stress. Choi, J. U., Voronina, N., Sun, Y. K. & Myung, S. T. Recent Progress and Perspective of Advanced High-Energy Co-Less Ni-Rich Cathodes for Li-Ion Batteries: Yesterday, Today, and Tomorrow. Adv. Energy Mater. 10 , 1–31 (2020). Li, H. et al. An Unavoidable Challenge for Ni-Rich Positive Electrode Materials for Lithium-Ion Batteries. (2019) doi:10.1021/acs.chemmater.9b02372. Yan, W., Yang, S., Huang, Y., Yang, Y. & Guohui Yuan. A review on doping/coating of nickel-rich cathode materials for lithium-ion batteries. J. Alloys Compd. 819 , 153048 (2020). Nam, G. W. et al. Capacity Fading of Ni-Rich NCA Cathodes: Effect of Microcracking Extent. ACS Energy Lett. 4 , 2995–3001 (2019).

Single‐Crystalline Ni‐Rich LiNi <i> <sub>x</sub> </i> Mn <i> <sub>y</sub> </i> Co <sub>1−</sub> <i> <sub>x</sub> </i> <sub>−</sub> <i> <sub>y</sub> </i> O <sub>2</sub> Cathode Materials: A Perspective (Adv. Energy Mater. 45/2022)

Radially Oriented Single‐Crystal Primary Nanosheets Enable Ultrahigh Rate and Cycling Properties of LiNi0.8Co0.1Mn0.1O2 Cathode Material for Lithium‐Ion Batteries

Lithium‐Ion Batteries: Radially Oriented Single‐Crystal Primary Nanosheets Enable Ultrahigh Rate and Cycling Properties of LiNi 0.8 Co 0.1 Mn 0.1 O 2 Cathode Material for Lithium‐Ion Batteries (Adv. Energy Mater. 15/2019)

Cathode Materials of Li_xCo_(0.8)Ni_(0.2)O_2 for Lithium-ion Battery

Single‐Crystalline Ni‐Rich LiNixMnyCo1−x−yO2 Cathode Materials: A Perspective

Synthesis and Electrochemical Characteristics of Li₁.₂(Ni₀.₂Mn₀.₆)ₓ(Co₀.₄Mn₀.₄)y(Ni₀.₄Mn₀.₄)₁₋ₓ₋yO₂ (0 ≤ X + Y ≤ 1) Cathode Materials for Lithium Ion Batteries

Challenges and approaches of single crystal Ni-rich layered cathodes in lithium batteries

Research Progress on Enhancing the Performance of High Nickel Single Crystal Cathode Materials for Lithium-Ion Batteries

Synthesis of Single Crystal LiNi 0.92 Co 0.06 Mn 0.01 Al 0.01 O 2 Cathode Materials with Superior Electrochemical Performance for Lithium Ion Batteries

Insight of Synthesis of Single Crystal Ni‐Rich LiNi1−x−yCoxMnyO2 Cathodes

One-Step Synthesis of a Single-Crystal LiNi 0.83 Co 0.11 Mn 0.06 O 2 Cathode with Excellent Electrochemical Properties by Ti 4+ Doping and LiTi 2 O 4 In Situ Chemical Coating Using a Novel Variable Temperature Sintering Process

A short process and low-cost preparation of single crystal LiNi0.6Co0.2Mn0.2O2 cathode for lithium-ion batteries

A Comparative Investigation of Single Crystal and Polycrystalline Ni‐Rich NCMs as Cathodes for Lithium‐Ion Batteries

Decoupling the Roles of Ni and Co in Anionic Redox Activity of Li-rich NMC Cathodes.

Electrochemical performances of nickel‐rich single‐crystal LiNi0.83Co0.12Mn0.05O2 cathode material synthesized by tuning Li+/Ni2+ mixing

Pushing the Energy-Lifetime Frontier of Li-Ion Batteries with Optimized Ni-Rich, Co-Free NMA-W Cathodes

Engineering Commercial Polycrystalline Precursor to Single Crystal Ni-rich Cathode with Outstanding Long-Cycle Performance

A single-crystal nickel-rich material as a highly stable cathode for lithium-ion batteries

Synthesis and Manipulation of Single-Crystalline Lithium Nickel Manganese Cobalt Oxide Cathodes: A Review of Growth Mechanism

Synthesis of single-crystal LiNi0.8Co0.1Mn0.1O2 materials for Li-ion batteries by microfluidic technology

Systematic Optimization of Battery Materials: Key Parameter Optimization for the Scalable Synthesis of Uniform, High-Energy, and High Stability LiNi 0.6 Mn 0.2 Co 0.2 O 2 Cathode Material for Lithium-Ion Batteries