Abstract:Zn modified ZSM-5 zeolite supported Ni bifunctional catalysts were prepared by in-situ hydrothermal synthesis (Zn-Ni-ZSM-5), co-impregnation method (Zn-Ni/ZSM-5) as well as combining in-situ hydrothermal synthesis of Zn-ZSM-5 and sequential impregnation of Ni (Ni/Zn-ZSM-5) and used for the selective converting olefin to aromatics applicable for FCC gasoline hydro-upgrading. The Lewis (L) acid sites generated by ZnOH+ species and hydrogenation active sites from Ni0 species were varied with preparation method, in which their locations at the external surface or micropores of zeolite changed the acid properties of catalysts. Comparing to the Zn-Ni/ZSM-5 from the co-impregnation method, direct in-situ hydrothermal method could incorporate Zn and Ni species within zeolite, which makes the strong interaction between the metal species and the framework Al to form medium-strong L acids (ZnOH+/NiOH+). This leads to the decrease of ratio of Brønsted acid sites to L acid sites (B/L) from 0.40 to 0.12 and the difficulty in reducing of Ni cations to Ni0 from 57% to 30% Ni0 percent. Ni/Zn-ZSM-5 sample prepared by incorporating Zn species into micropores and sequential depositing Ni species at the external surface of zeolite possesses a low B/L ratio similar to Zn-Ni-ZSM-5 (0.20 versus 0.12) but a much higher Ni0 percent (52% versus 30%). Zn-Ni-ZSM-5 shows closer intimacy between Zn and Ni species comparing to Zn-Ni/ZSM-5 and Ni/Zn-ZSM-5. For the 1-hexene aromatization, the formed iso-alkene at acid sites was quickly saturated to iso-alkanes by the adjacent Ni0 particles over Ni-Zn-ZSM-5 catalyst in hydrogen steam. However, the location of aromatization active sites (ZnOH+, L acid sites) in micropores and hydrogenation active sites (Ni0 species) on external surface of Ni/Zn-ZSM-5 makes the tandem conversion of n-alkene → iso-alkene → aromatics, rather than the n-alkene → iso-alkene → iso-alkane. Thus, Zn-Ni-ZSM-5 with close intimacy of ZnOH+ and Ni0 particles shows a high iso-alkane selectivity (27.9% iC4 +), while Ni/Zn-ZSM-5 exhibits a high aromatics selectivity (39.6 %) in the conversion of 1-hexene in hydrogen steam. Similar results have also found in the conversion of n-heptane. Here, the control of the intimacy of Zn and Ni in ZSM-5 zeolites has been realized to be a good protocol to adjust the selective conversion of olefins/alkanes to aromatics versus iso-alkanes.

Hydrothermal catalytic conversion of oleic acid to heptadecane over Ni/ZrO2

Efficient and Stable Cu-Ni/ZrO2 Catalysts for in Situ Hydrogenation and Deoxygenation of Oleic Acid into Heptadecane Using Methanol As a Hydrogen Donor

Highly Efficient Conversion of Oleic Acid to Heptadecane Without External Hydrogen Source over Atomic Layer Deposited Bimetallic NiPt Catalysts

In Situ Hydrogenation and Decarboxylation of Oleic Acid into Heptadecane over a Cu–Ni Alloy Catalyst Using Methanol As a Hydrogen Carrier

Hydrodecarboxylation of fatty acids into liquid hydrocarbons over a commercial Ru/C catalyst under mild conditions

Highly Efficient N-Doped Carbon-Supported Subnanometer Cobalt–Zinc Bimetallic Catalysts for Decarbonylation of Fatty Acids into Long-Chain Olefins

Bifunctional CuNi/CoOx catalyst for mild-temperature in situ hydrodeoxygenation of fatty acids to alkanes using isopropanol as hydrogen source

Catalytic Hydrogenation of Levulinic Acid to Gamma-Valerolactone over Ni/ZrO2

Catalytic Decarbonylation Of Stearic Acid To Hydrocarbons Over Activated Carbon-Supported Nickel

Catalytic Deoxygenation of C18 Fatty Acid over Supported Metal Ni Catalysts Promoted by the Basic Sites of ZnAl2O4 Spinel Phase

Highly Selective Hydrodecarbonylation of Oleic Acid into N‐heptadecane over a Supported Nickel/Zinc Oxide–Alumina Catalyst

Tuning electron density of metal nickel by support defects in Ni/ZrO2 for selective hydrogenation of fatty acids to alkanes and alcohols

Preparation of Reduced Ni-Nb-O Composite Hydrogenation Catalysts for Highly Selective Conversion of Free Fatty Acids to N-Alkanes

Efficient and Stable Ni-Cu Catalysts for Ex Situ Catalytic Pyrolysis Vapor Upgrading of Oleic Acid into Hydrocarbon: Effect of Catalyst Support, Process Parameters and Ni-to-Cu Mixed Ratio

Preparation of Metal-Acid Bifunctional Catalyst Ni/Zsm-22 for Palmitic Acid Catalytic Deoxygenation

Hydrothermal stable Ni nanoparticles encapsulated in carbon for hydrothermal hydrogenation of long-chain fatty acids to alkanes

Enhancement of fatty acids hydrodeoxygenation selectivity to diesel-range alkanes over the supported Ni-MoOx catalyst and elucidation of the active phase

Synthesis and consequence of Zn modified ZSM-5 zeolite supported Ni catalyst for catalytic aromatization of olefin/paraffin

Hydrothermal Hydrogenation/deoxygenation of Palmitic Acid to Alkanes over Ni/activated Carbon Catalyst

Non-precious Metal Catalyst, Highly Efficient Deoxygenation of Fatty Acids to Alkanes with in Situ Hydrogen from Water

In Situ Hydrogenation of Methyl Palmitate to Hexadecanol on TiO2- and ZrO2-Supported Ni-In Catalysts in the Aqueous Phase Using Methanol As a Hydrogen Donor