Abstract:The underwater shield tunnel, as a critical engineering project spanning rivers and seas, has entered a phase of rapid development. However, the large-section underwater shield tunnel faces significant challenges due to the complexity of its geological and hydrological environment, which subjects it to high load conditions, such as water and earth pressures. These challenges pose severe risks to the structural safety of the tunnel and substantially compromise traffic safety. Consequently, the investigation of tunnel segment structures has emerged as a key area of research. Traditional studies have often focused on the elastic or failure stages of the segments, neglecting the deformation characteristics of the segments under various stress states throughout their operational lifespan. This study employs full-scale testing methods alongside fiber Bragg grating (FBG) sensing technology to gather elastic strain data from the tunnel segments under varying conditions, including earth pressure, water pressure, lateral pressure coefficients, and the positioning of sealing blocks. Additionally, it analyzes strain data during the micro-cracking and damage phases, exploring the circumferential strain patterns that arise. In contrast to numerical simulations or scaled model tests, full-scale testing allows for direct observation and measurement of the deformation and failure processes of the tunnel segments under realistic engineering conditions, thereby providing a more accurate representation of actual conditions and enhancing the reliability of the research findings. The results indicate that elevated water pressure significantly reduces the circumferential strain of the tunnel segments, thereby decreasing the degree of structural deformation. An increased lateral pressure coefficient also markedly mitigates these effects. To ensure the structural safety of cracked tunnel segments, vertical ground pressure must not exceed 4 MPa when water pressure is at 40 m and the lateral pressure coefficient is 0.5. Furthermore, under hydraulic loads of 80 m, if vertical earth pressure exceeds 14.7 MPa, a stress redistribution occurs, causing the arch bottom strain to transition to a compressive state. Thus, the industry can utilize the deformation characteristics of segments at various stages presented in this study to optimize design parameters, formulate targeted maintenance strategies, and prevent structural damage, thereby ensuring the safety of tunnel structures and extending their service life.

Research on Void Defect Distribution Law and Structural Optimization Design of Sandwich-Structured Immersed Tunnel in the Shenzhen-Zhongshan Channel

Void Detection and Void Defect Control Methods for Large-Scale Immersed Steel Shell–concrete Tunnels

Design Scheme and Structure Analysis of Dongwuyang Submerged Floating Tunnel

Nondestructive millimeter-scale void detection for thick steel-shell–concrete interface of immersed tube tunnel: case study

Some Key Problems Of High Performance Fiber Reinforced Concrete Submerged Floating Tunnel

Simulation Analysis of Void Defect Detection in Sandwich-Structured Immersed Tunnel Using Elastic Wave

Experiments and Numerical Simulation of the Reinforcement Effect of Channel-Steel-reinforced Shield Tunnel Segments under Unloading Conditions

Model tests on compression of base layer of immersed tube tunnels considering siltation

Experimental and Numerical Investigation of the Cross-Sectional Mechanical Behavior of a Steel–Concrete Immersed Tube Tunnel

MODEL TEST RESEARCH OF BASE LAYER COMPRESSION FEATURE IN SUBMARINE IMMERSED TUBE TUNNEL

Analysis of Settlement Control Measures in Immersed Tunnel

Vibration Response Analysis of Submerged Floating Tunnel in Dongwuyang Fiord in Normal Service Condition

Research on tubular segment design of submerged floating tunnel

Dynamic behavior analysis of high performance fiber concrete submerged floating tunnel tube under collision

Application of Impact Imaging Method on Nondestructive Detection of Void Defects in Sandwich-Structured Immersed Tunnel

Study on Deformation Characteristics of Segment Joints of the Immersed Tunnel in Hong Kong-Zhuhai-Macau Bridge

Study on deformation characteristics of composite lining structure of shield tunnel

Causes and treatment measures of large deformation and failure of the box-frame channel above an under-construction underpass tunnel

Research on the ring strain of the segment for large-section underwater shield tunnels

Investigating the Deformation and Failure Mechanism of a Submarine Tunnel with Flexible Joints Subjected to Strike-Slip Faults

Evaluation on the State of Sand Filling Layer and the Influence on Segment Deformation of Immersed Tunnels