Abstract:The external piping system which connects power devices, valve control devices, actuators, etc. is an essential system on the aero engine. Under the combined effects of high fluid pressure and external vibration, multiaxial fatigue failure is the main factor that seriously affects the safety of the piping system. The objective of this paper is to establish the multiaxial fatigue life model for the typical welded fuel pipe of the piping system by combining fatigue testing, simulation and theoretical analysis which is of great guiding significance for the engineering application of the piping system. Firstly, the fatigue limits of welded fuel pipes under no and 13.5 MPa internal pressure are obtained by rotational bending fatigue tests using the up-and-down method. Three additional stress levels of rotational bending fatigue tests under no internal pressure are supplemented and then the S-N curve is further obtained by the group method. Since the corresponding fracture surface of the specimens locates at the weld toe near the fixed end, peak stress method is adopted to evaluate the fatigue performance of the weld toe on the pipe specimens. In addition, by comparing the fatigue limit with no and 13.5 MPa internal pressured pipes, it is obvious that the equivalent uniaxial stress corrected by Gerber formula is not applicable for the multiaxial fatigue condition which is caused by the combined effect of fluid pressure and displacement load. The local stress concentration factor caused by the weld toe is determined and based on Findley critical plane model, the multiaxial fatigue life model is established which simultaneously takes the local stress concentration effect, mean stress effect and multiaxial stress effect into consideration. The results of rotational bending fatigue tests under 13.5 MPa internal pressure are within the triple error dispersion band and the accuracy of the proposed life model are verified.

Fatigue Life Prediction and Experiment of an Axle Housing Considering Welding Residual Stresses

Prediction of Fatigue Life for Automotive A-Alloy Wheel with Integrated Cast Defects

ALUMINUM ALLOY WHEEL BENDING TEST FATIGUE LIFE PREDICTION

Fatigue Performance Testing and Life Prediction of Welded Fuel Pipes

Numerical Prediction and Control of Deformation and Residual Stress in Double-Sided Arc Welding of Large Pressure Hull

Research on fatigue reliability prediction model and structural improvement of welded drive axle housing based on master S‐N Curve method

FINITE ELEMENT SIMULATION AND TEST FOR FATIGUE LIFE OF COMMERCIAL VEHICLE DRIVING AXLE HOUSING

Fatigue life prediction of 316L stainless steel weld joint including the role of residual stress and its evolution: Experimental and modelling

FATIGUE LIFE PREDICTION OF VEHICLE'S DRIVING AXLE HOUSE UNDER RANDOM LOADING

Analysis and modeling of the strength,life and reliability of an automobile component

Strength and Life Analysis of a Heavy Truck Axle Housing

Multiaxial Fatigue Life Prediction Based on Damage Mechanics and Critical Plane Method

Fatigue Life Prediction of Seam Weld in the Automotive Structure

Numerical simulation and analysis of welding of drive axle housing and axle tube

Low Cycle Fatigue Properties and Fracture Mechanism of Q345qC Steel and Its Welded Joint

Fatigue life prediction for butt-welded joints considering weld-induced residual stresses and initial damage, relaxation of residual stress, and elasto-plastic fatigue damage

Pre-Estimation of Fatigue Lifetime of Welding Spots of BIWs

Stress Analysis and Lifetime Prediction for Ti–6Al–4V Welding Joint under Fatigue Loading

Simulation of the Vertical Bending Fatigue Test of a Five-Link Rear Axle Housing

Fatigue life prediction for Al–Zn–Mg alloy butt welded joints based on a fatigue damage model accounting for the influence of interior porosity

Analysis and Improvement of Rear Axle Housing Fatigue Life Based on Vehicle Dynamics Simulation