Abstract:Associated with uneven heat transfer in molds, longitudinal off-corner depressions (LOCDs) have been identified as a general defect on wide–thick slabs during continuous casting. Additionally, the concurrent surface and subsurface cracks accompanying LOCDs consistently undermine the quality of high-end steel production. To control LOCDs and crack defects, a multibody and multifield coupling model is developed, upon which a convex-structure mold (CSM) is designed and optimized. In this work, the model is extended to cover the mold, secondary cooling zones, and reduction segments. Thus, the shell deformation can be described during the full process of continuous casting. Based on the model, the CSM is thoroughly compared with a traditional flat-plate mold (FPM) in terms of contact status, air gap expansion, interfacial heat transfer, shell growth, shell deformation, and LOCD formation. The results show that shell shrinkage in the FPM causes a larger contact gap at the corners. Consequently, thick slag layers and air gaps forming around shell corners lead to a hot (thin) spot at the wide face off-corner. With the corner gaps being closed in the CSM, the shell growth at the off-corner is homogenized, and the local hot spot disappears. In secondary cooling zones, the solidifying shell cast by the FPM undergoes larger deformation due to the thin spot. However, uniform shell growth in the CSM could avoid concentrated stress and increase the resistance to deformation. Therefore, the width and depth of the LOCD are greatly reduced throughout the continuous casting process. At the end of mechanical reduction, the depths of the LOCDs in the FPM and CSM cases are 1.77 and 1.1 mm, which correspond to heavy and slight defect levels, respectively. Through these numerical comparisons, the advantages of CSMs in controlling LOCDs are finally confirmed.

Slab shell deformation behavior in ultra-high speed thin slab continuous casting mold

Simulation Analysis of Thermal Stress During Casting Process of Large-Sized Alloy Steel Ingot

Heat transfer behavior in ultrahigh-speed continuous casting mold

Analysis of Longitudinal Cracking and Mold Flux Optimization in High-Speed Continuous Casting of Hyper-Peritectic Steel Thin Slabs

Continuous Casting Mould for Square Steel Billet Optimised by Solidification Shrinkage Simulation

Study on solidification and heat transfer of billet shell in a new-structure high-speed continuous casting mold

Chamfer and Taper Researches of Mould in Slab Continuous Casting

Thickness Distributions of Mold Flux Film and Air Gap in Billet Ultra-High Speed Continuous Casting Mold Through Multiphysics Modeling

Thermo-mechanical Modeling in Continuous Slab Casting Mould and Its Application

Study on Mushy Zone Coefficient in Solidification Heat Transfer Mathematical Model of Thin Slab with High Casting Speed

A Novel Control Technique for Longitudinal Off-Corner Depressions on Wide Faces of Continuous Casting Slabs: Effect of the Mold Design on Controlling LOCDs

Investigation on non-uniform friction behaviors of slab during continuous casting based on an inverse algorithm

Heat-transfer and solidification model of continuous slab casting: CON1D

A coupled model on fluid flow, heat transfer and solidification in continuous casting mold

Analysis of heat transfer and thermal stress in continuous casting with mechanical reduction

Fluid flow and solidification in continuous thin slab casting mold

Optimization of Flow Field in Slab Continuous Casting Mold with Medium Width Using High Temperature Measurement and Numerical Simulation for Automobile Exposed Panel Production

Numerical Simulation on Free Surface in the Mold of Slab Continuous Caster at Low Casting Speed with MFCD

Transient flow and mold flux behavior during ultra-high speed continuous casting of billet

Optimization of Billet Tube Mold Designs for High-Speed Continuous Casting

Numerical Study on Characteristic Positions and Transition of Flow Patterns in a Slab Continuous Casting Mold