Abstract:Ultra-high-performance concrete possesses extraordinary strength and durability. However, the high preparation cost of UHPC limits its large-scale engineering application. Recently, some studies have been done on the incorporation of granite powder (GP) in UHPC. It is reported that the granite powder possesses low pozzolanic activity and could replace part of quartz powder (QP) under autoclave curing. However, the silica fume (SF) would preferentially consume the Ca(OH)(2) generated from the hydration to some extent, where the inert powder like granite powder or quartz powder could hardly participate in the pozzolanic activity due to low Ca(OH)(2) content. In this research, the properties of UHPC incorporated by the silica fume and the inert powders like granite and quartz powder were studied, which are SF20, GP20A, GP20B, QP20A and QP20B respectively. Then the hydration products and microstructure of them were analyzed by the X-ray diffraction (XRD), field emission scanning electron microscope (FE-SEM), Energy Dispersive Spectrometer (EDS), Si-29 nuclear magnetic resonance (NMR), and Mercury intrusion porosimetry (MIP). Results demonstrated that the replacement of inert powders to SF greatly lowers the rheological parameters like shear stress and apparent viscosity, and improvs the flowability. And the sample SF20 possesses the highest mechanical strength due to its dense pore structure, of which the compact tobermorite was found in the products but few Ca(OH)(2) was found. Besides, the compressive strengths of samples QP20A and QP20B were close to SF20 because their similar hydration products, pore size distribution and mean chain lengths (MCL). Due to the lower reaction activity of GP-A, the sample GP20A possessed the lowest strength but the highest pore diameter and porosity. While the grounded granite powder showed the higher reaction activity, resulting in the formation of tobermorite and a finer pore size distribution and the higher strength in GP20B. Hence, it can be concluded that the pozzolanic activity of inert powders, the quartz powder and the granite powder, could be greatly improved by autoclave curing and reducing the particle size. This study provides the theoretical basis for replacement for silica fume with inert powder and the possibility to reduce the preparation cost of UHPC and to enlarge its application.

Effect of Industrial-Grade Heavy Calcium Carbonate Powder on Properties of White High-Strength Concrete

Mechanism Underlying Early Hydration Kinetics of Carbonated Recycled Concrete Fines-Ordinary Portland Cement (CRCF-OPC) Paste

Powder Gradation Effect on the Fresh, Mechanical, and Early-Age Shrinkage Properties of UHPC

Design and Preparation of White High-Strength Concrete with Ground Limestone Powder by Means of Response Surface Methodology

Mechanical Properties and Shrinkage of Ultrahigh-Performance Concrete Containing Lithium Carbonate and Nano-Calcium Carbonate

Efficient Utilization of Waste Marine Clay for Fine Aggregate to Develop Sustainable and Cost-Effective Strain-Hardening Cement-Based Composites

[math] Treatment of Hydrated Cement Powder: Characterization and Application Consideration

Ultra-high performance concrete prepared with ceramic polishing waste: Hydration, microstructure and mechanical property

Performance and Microstructure of Ultra-High-performance Concrete (UHPC) with Silica Fume Replaced by Inert Mineral Powders

Evaluation of mechanical properties and environmental impact of using limestone powder in high performance concrete

Study on the Influence of SAP on Properties of White Fair-Faced Concrete with Limestone Powder

Hydration mechanism and mechanical properties of a developed low-carbon and lightweight strain-hardening cementitious composites

Effects of HPMC on Workability and Mechanical Properties of Concrete Using Iron Tailings as Aggregates

Preparation of Nano Calcite by the Carbon Capture Technology to Improve the Performance of Ultrahigh-Performance Concrete Containing Calcined Clay

Effect of Ceramic Waste Powder on Mechanical Properties of Recycled Coarse Aggregate Concrete

Influence of Ground Calcium Carbonate Waste on the Properties of Green Self-Consolidating Concrete Prepared by Low-Quality Bagasse Ash and Rice Husk Ash

Effect of calcined bauxite powder or aggregate on the shrinkage properties of UHPC

Effects of C-S-H Seed Prepared by Wet Grinding on the Properties of Cement Containing Large Amounts of Silica Fume

Mechanical properties and microstructure of ultra-high performance concrete with low cement content

Properties of High-Volume Limestone Powder Concrete under Standard Curing and Steam-Curing Conditions

Study on workability and mechanical strength of low cement ultra-high performance concrete with ultrafine quartz powder as alternative material under high temperature curing