Abstract:The use of Ni-based catalysts is a common method for eliminating tar through catalytic cracking. Carbon deposition is the main cause of deactivation in Ni/ZSM-5 catalysts, with filamentous MWCNTs being the primary form of carbon deposits. This study investigates the formation and evolution of CNTs during the catalytic process of biomass tar to explore the mechanism behind carbon deposition. The effect of the 9Ni/10MWCNTs/81ZSM-5 on toluene reforming was investigated through a vertical furnace. Gases produced by tar catalysis were evaluated through GC analysis. The physicochemical structure, properties and catalytic performance of the catalyst were also tested. TG analysis was used to assess the accumulation and oxidation reactivity of carbon on the catalyst surface. An analysis was conducted on the mechanism of carbon deposition during catalyst deactivation in tar catalysis. The results showed that the 9Ni/91ZSM-5 had a superior toluene conversion of 60.49%, but also experienced rapid and substantial carbon deposition up to 52.69%. Carbon is mainly deposited as curved filaments on both the surface and pore channels of the catalyst. In some cases, tip growth occurs where both carbon deposition and Ni coexist. Furthermore, specific surface area and micropore volume are reduced to varying degrees due to carbon deposition. With the time increased, the amount of carbon deposited on the catalyst surface increased to 62.81%, which gradually approached saturation, and the overall performance of the catalyst was stabilized. This situation causes toluene molecules to detach from the active sites within the catalyst, hindering gas release, which leads to reduced catalytic activity and further carbon deposition. It provides both a basis for the development of new catalysts and an economically feasible solution for practical tar reduction and removal.

Study on the construction of char-supported NiFe-NiFe2O4 catalyst and its catalytic cracking mechanism of biomass tar under relative low temperature

A Highly Efficient Bimetallic/biochar Composite with Enhanced Catalytic Reforming of Pyrolysis Tar: Performance and Mechanism

Preparation and characterization of furfural residue derived char-based catalysts for biomass tar cracking

Low-Temperature Catalytic Cracking of Biomass Gasification Tar over Ni/HZSM-5

Biomass-Derived Bimetallic Ni-Fe Catalyst with Enhanced Tar Removal Performance

Construction of Fe embedded graphene nanoshell/carbon nanofibers catalyst for catalytic cracking of biomass tar: Effect of CO2 etching

Low-Temperature Steam Reforming of Toluene and Biomass Tar over Biochar-Supported Ni Nanoparticles

Insight into the Ex Situ Catalytic Pyrolysis of Biomass over Char Supported Metals Catalyst: Syngas Production and Tar Decomposition

Heterogeneous Cracking Reaction of Tar over Biomass Char, Using Naphthalene As Model Biomass Tar

Performance of catalytic cracking of biomass tar and catalyst preparation

Synthesis of biomimetic monolithic biochar-based catalysts for catalytic decomposition of biomass pyrolysis tar

Comparative evaluation of tar steam reforming over graphitic carbon supported Ni and Co catalysts at low temperature

Enhanced Low-temperature Catalytic Decomposition Performance of Naphthalene over Hydrothermal Carbon-based Nanomaterials with a Hierarchical Heterostructure

One-step preparation of char-supported iron nanocatalysts under microwave irradiation and their application for tar removal

Catalytic Pyrolysis of Tar Model Compound with Various Bio-Char Catalysts to Recycle Char from Biomass Pyrolysis

Development of nano-niO/Al2O3 catalyst to be used for tar removal in biomass gasification

Catalytic Cracking and Catalyst Deactivation/regeneration Characteristics of Fe-loaded Biochar Catalysts for Tar Model Compound

Preparation of highly dispersed lignite-char-supported cobalt catalyst for stably steam reforming of biomass tar at low temperature

Study on the mechanism of carbon nanotube-like carbon deposition in tar catalytic reforming over Ni-based catalysts

Catalytic conversion of toluene as a biomass tar model compound using monolithic biochar-based catalysts decorated with carbon nanotubes and graphic carbon covered Co-Ni alloy nanoparticles