Abstract:The structural evolutions of linear low-density polyethylene (LLDPE) are investigated by in-situ synchrotron radiation wide-angle X-ray diffraction (WAXD) during tensile deformation over a wide strain rates range from 0.005 to 250 s−1. The phase transition mechanism is discussed by combining the phase diagram in 2D true stress (σtrue)-strain rate (<math>ε˙</math>) space with the evolutions of several micro-structural parameters, such as the crystallinity (χc), crystal sizes (L110, L200) and lattice parameters (aO, bO). The true stress space can be roughly divided into three regions by two critical true stresses at the onset formation of the monoclinic (σM-onset) and the hexagonal (σH-onset) crystals. In region I where only orthorhombic crystals exist, lattice distortion under the effects of stress plays a dominant role. In region II, the martensitic transformation from orthorhombic to monoclinic crystals occurs and monoclinic crystals load the main tensile stress. In region III, stress-induced melt recrystallization occurs and hexagonal crystals appear. In addition, the effects of strain rate on the stress-induced melt crystallization and lattice deformation are also discussed. This study on LLDPE films might aid to deepen the understanding of structural evolutions during real post-stretching process.

Structural Evolution of UHMWPE Fibers During Poststretching with Distinct Initial Structures

Structural Evolution of UHMWPE Fibers During Prestretching Far and Near Melting Temperature: an in Situ Synchrotron Radiation Small‐ and Wide‐Angle X‐Ray Scattering Study

Effects of stretching on crystalline phase structure and morphology of hard elastic PVDF fibers

A Study on the Relationship Between the Crystal Structure and Hard Elasticity of PVDF Fibers

Study on Structures and Properties of Ultra-Hot Drawing UHMWPE Fibers Fabricated Via Dry Spinning Method

Extended Chain Crystals of Ultra High Molecular Weight Polyethylene Fiber Prepared by Melt Spinning

Stretch-induced structural transition of linear low-density polyethylene during uniaxial stretching under different strain rates

Reversed thermal stability between stress-induced melting and recrystallized crystallites and original inclined ones in moderately stretched ultra high molecular weight polyethylene and high density polyethylene

Structure and Properties of Gel‐spun Ultra‐high Molecular Weight Polyethylene Fibers Obtained from Industrial Production Line

Structural evolution of ultra-high molecular weight polyethylene gel film stretching at different temperatures with reservation of shish crystals

Deformation of Ultrahigh Molecular Weight Polyethylene Precursor Fiber: Crystal Slip with or Without Melting

The Structure Evolution of Polyamide 1212 after Stretched at Different Temperatures and Its Correlation with Mechanical Properties

Study of deformation behavior of ultra-high molecular weight polyethylene (UHMWPE)

Study of the Microstructure Formation Mechanisms of Poly(ether‐ether‐ketone) Monofilaments Via Melt Spinning

Structure Evolution of Polyethylene in Sequential Biaxial Stretching along the First Tensile Direction

Biaxial stretch-induced structural evolution of polyethylene gel films: Crystal melting recrystallization and tilting

An In-Situ X-Ray Scattering Study During Uniaxial Stretching of Ionic Liquid/Ultra-High Molecular Weight Polyethylene Blends

Evolution of the cavity structure of HDPE/UHMWPE blends during cold stretching

Structure Evolution Of Ultra High Molecular Weight Polyethylene/Montmorillonite Nanocomposite Fibers Prepared By Melt Spinning

Shish-kebab Structure Evolution of HDPE/UHMWPE During Hot Drawing

Shish‐kebab structure evolution of <scp>HDPE</scp>/<scp>UHMWPE</scp> during hot drawing