Enhancement Role of Nitrates and Carbonates Loaded in Mgo Sorbents for Low-Concentration Co2 Capture and Desorption by H2 Purge for Methanation

Yuxuan Qiu,Yifan Cai,Mengjie Luo,Ze Sun,Ping Li
DOI: https://doi.org/10.2139/ssrn.4393907
2023-01-01
Abstract:Three kinds of sorbents, including (NaNO3)0.1-MgO (sorbent 1), (NaNO3)0.1(Na2CO3)0.05-MgO (sorbent 2), (Li/KNO3)0.1(Na2/K2CO3)0.05-MgO (sorbent 3) are prepared and formed into granules for the low-content CO2 capture (10% -50% CO2 with N2 impurity) in the fixed bed. XRD, FESEM, and BET characterizations are adopted to analyze the microstructure change of the prepared sorbents before and after used. The thermogravimetric analysis tests are carried out to evaluate CO2 adsorption/desorption rates and the cyclic stabilities of sorbents. The breakthrough behaviors of the low-content CO2 gas are investigated experimentally. Because there exists CO2 diffusion resistance in the molten salt layer on the surface of sorbents, and a certain CO2 partial pressure is required as the mass transfer driving force for CO2 adsorption, resulting in a lower CO2 adsorption efficiency. The alkalinity improvement in the molten salt layer, such as sorbent 3 with carbonates addition, can reduce the required CO2 partial pressure to enhance the low-content CO2 capture. Moreover, CO2 desorption performances are compared experimentally between N2 purge and H2 purge in the packed column, and small molecule H2 has a faster mass transfer rate to shorten the desorption time obviously. Furthermore, the integrated process of low-content CO2 capture, desorption by H2 purge and methanation is developed and demonstrated experimentally in the sorbent 3 packed column. 10%-30% CO2 in feed gas can be captured with 58%-79% adsorption efficiency at 285℃, and the adsorbed CO2 can be desorbed through H2 purge with 91%-99% desorption efficiency at 400℃, and the desorbed CO2 with the excess H2 can be converted completely into CH4 with 97%-99% CH4 selectivity and less than 3% CO selectivity at 400℃ with Ni-Al2O3 catalysts.
What problem does this paper attempt to address?