Abstract:To study the law that governs the complex movements of the mechanism in the process of automatic weapon operation, the velocity tracking test technology of photon Doppler velocimetry is introduced to accurately measure velocity, displacement and acceleration, on the condition that there are long displacement and rapid velocity change. In the traditional way, out of interference signal time-frequency (TF) transformation draws TF distribution, and then by modulus maxima frequency extraction, comes to the law of velocity change. Due to the influence resulting from the change of fundamental signal as well as that of light intensity signal in the test, based on the TF distribution obtained by TF transformation, the traditional modulus maxima frequency extraction can extract frequency signals, but they show abnormal sudden changes at some moments, making the velocity discontinuous, unsmooth and unreal, which brings obvious errors to the subsequent calculation of acceleration and accurate displacement. Addressing the above-mentioned problems, this paper proposes a ridge extracting correction algorithm based on modulus maxima frequency extraction; this method, based on a large number of experiments where rodless cylinders are used to simulate the motion of a gun automatic mechanism, conducts a detailed calculation and analysis of the experimental results. A comparison of the two algorithms’ processing results, in terms of the speed, displacement and acceleration, suggests that the ridge extracting correction algorithm successfully corrects the frequency selection error, which draws a more continuous and, therefore, effective curve of the velocity change, and by so doing, the error of the displacement test (within 1.36 m displacement) is reduced from more than 3.6% to less than 0.58%, and the uncertainty dropped 97.07%. All these show that the accurate measurement of velocity, displacement and acceleration, with sudden and rapid velocity changes considered, is realized successfully.

High-precision speed imaging using photon heterodyne detection based on a real-time noise-filtering algorithm

Low Noisy Dual Wavelength Digital Holography and Application in the Ultra-precision Machining Surface Measurement

Polarisation-modulated Photon-Counting 3D Imaging Based on a Negative Parabolic Pulse Model

Optimization of System Design and Calibration Algorithm for SPAD-Based LiDAR Imager

Measurement of Tiny Displacement with Fast Sampling by A Heterodyne Interferometer and Error Analysis

Micro-vibration measuring technology based on heterodyne interference

A real-time noise filtering strategy for photon counting 3D imaging lidar

High speed multi-beam photon-counting Lidar system

Research on Speed Measurement Signal Denoising Processing of Laser Doppler Vibrometer

Single-photon lidar depth imaging based on sparsity adaptive matching pursuit method

A photon-efficient method based on curve fitting for photon counting 3D imaging lidar

Noise-tolerant LiDAR approaching quantum-limited precision

High-resolution Imaging of a High-Speed Target Based on a Reconfigurable Photonic Fractional Fourier Transformer.

Full Waveform Recovery Method of Moving Target for Photon Counting Lidar

Microwave Photonic Based High-Resolution ISAR Imaging System for High-Speed Target

Microwave photonics doppler speed measurement based on sagnac loops and four-wave mixing effect in a highly nonlinear fiber

A High-Precision Phase-Derived Velocity Measurement Method for High-Speed Targets Based on Wideband Direct Sampling LFM Radar

Detection of moving objects using single-photon counting LIDAR

Strategies of precision enhancement for dual-comb time-of-flight distance measurement with nonlinear detection by numerical simulation

Coincidence Photon-Counting Laser Ranging for Moving Targets With High Signal-to-Noise Ratio

Reconstruction of Velocity Curve in Long Stroke and High Dynamic Range Laser Interferometry