Abstract:This study presents a detailed investigation into the deformation behaviour and the factors affecting the strength and ductility of laser powder bed fusion (LPBF) Ni-based superalloy 718 (Inconel 718) in both as-printed and heat-treated conditions using in-situ SEM + EBSD. The results show that following post-deposition high homogenization temperatures, the columnar grain structure of the as-printed Inconel 718 alloy successfully transformed to a nearly uniform grain size and the subsequent aging processes facilitated the precipitation of strengthening phases (gamma ', ' , gamma"). The specimen subjected to heat treatment (HT1) exhibited higher strength but lower ductility, while the as-printed specimen shows higher tensile elongation due to high initial dislocation density. In contrast, the heat-treated (HT2) specimen presented a more optimal combination of strength and ductility. The underlying mechanism for the enhanced tensile properties in the HT2 specimen was nearly homogeneous deformation trend across the grains and ultrafine precipitation of hardening phases. In addition, the twin boundaries were stable in the early deformation stages and maintained their orientation. Multiple slip systems were activated at the high-deformation stage, resulting in a high proportion of geometric necessary dislocations. Further, the interaction of deformation-induced dislocation with twin boundaries transformed them into general boundaries such as high and low-angle grain boundaries, ultimately increasing ductility. On contrary, in the HT1 specimen, the deformation inhomogeneity in grains enabled the strain localization at grain boundaries, which ultimately caused the early formation of cracks.

Thermal Evolutions of Residual Stress and Strain Hardening of GH4169 Ni-based Superalloy Treated by Laser Shock Peening

Mechanical Properties and Fracture Behavior of Laser Powder-Bed-Fused GH3536 Superalloy

Impact on Mechanical Properties and Microstructural Response of Nickel-Based Superalloy GH4169 Subjected to Warm Laser Shock Peening

Characteristics of microstructure evolution of surface treated IN718 superalloy by warm laser shock peening during long-term aging at high temperatures

Comparison of surface integrity of GH4169 superalloy after high-energy, low-energy, and femtosecond laser shock peening

Study on stress relaxation characteristics of FGH95 powder superalloy treated by laser shock peening

Improvement of Fatigue Life of GH3039 Superalloy by Laser Shock Peening

Quantification of room temperature strengthening of laser shock peened Ni-based superalloy using synchrotron microdiffraction

Microstructural evolution and mechanical behaviors of Al-Cu-Li alloy processed by laser shock peening

The strengthening mechanism of a nickel-based alloy after laser shock processing at high temperatures

Effect of laser shock peening on the tensile behavior and notch sensitivity of Ni-based single-crystal superalloy

Investigation of High-Temperature Recovery and Recrystallization Behavior in a Single Crystal Ni-Based Superalloy Treated with Shot Peening and Laser Peening

Insight into Elongation and Strength Enhancement of Heat-Treated LPBF Ni-based Superalloy 718 Using In-Situ SEM-EBSD

Effect of Warm Laser Shock Peening on the Low-Cycle Fatigue Behavior of DD6 Nickel-Based Single-Crystal Superalloy

Effect of laser shock peening without coating on fretting wear behavior of GH4169 superalloy at high-temperature

Effect of stress-relief heat treatment on the stress-rupture properties of a nickel-based superalloy manufactured by laser powder bed fusion

Analysis of microstructure and high-temperature tensile properties of 2060 Al-Li alloy strengthened by laser shock peening

Thermo-mechanical simulation of annealing heat treatment of Ni-based GH4099 superalloy made by laser powder bed fusion

Laser shock peened Ti-6Al-4 V alloy: Experiments and modeling

Effect of Preliminary Heat Treatment on the Formation of Structure and Residual Stresses in the AMg6 Alloy at Laser Shock Peening Without Coating