Abstract:By harnessing gasoline’s low reactivity for partially premixed combustion promotion, gasoline compression ignition (GCI) combustion shows the potential to produce markedly improved NOx-soot trade-off with high fuel efficiency compared to conventional diesel combustion. However, at low-load conditions, gasoline’s low reactivity poses challenges to attaining robust combustion with low unburned hydrocarbons (UHC) and carbon monoxide (CO) emissions. Increasing the in-cylinder charge temperature by using variable valve actuation (VVA) can be an effective means to address these challenges. In this numerical investigation, VVA strategies, including (1) early exhaust valve opening (EEVO), (2) positive valve overlap (PVO), and (3) exhaust rebreathe (ExReb), were investigated at 1375 RPM and 2 bar brake mean effective pressure in a heavy-duty GCI engine using a market-based gasoline with a research octane number (RON) of 93. The total residual gas level was kept over 50% to achieve an engine-out NOx target of below 1.5 g/kWh. For a complete engine system analysis, one-dimensional (1-D) system-level modeling and three-dimensional (3-D) computational fluid dynamics (CFD) analysis were close-coupled in this study. Performance of the VVA strategies was compared in terms of in-cylinder charge and exhaust gas temperatures increase versus brake-specific fuel consumption (BSFC). The EEVO strategy demonstrated in-cylinder charge and exhaust temperature increase up to 130 and 180 K, respectively. For similar in-cylinder charge temperature gains, the ExReb strategy demonstrated 11% to 18% lower BSFC compared to the EEVO strategy. This benefit primarily originated from a more efficient gas-exchange process. The PVO strategy, due to the valve–piston contact constraint, required excessive exhaust back-pressure valve (BPV) throttling for hot residuals trapping, thereby incurring higher BSFC compared to ExReb. In addition, the ExReb strategy demonstrated the highest potential for exhaust temperature increase (up to 673 K) among the three strategies. This was achieved by ExReb’s maximum air-fuel ratio reduction from high internal residuals mass and BPV throttling. Finally, the ExReb profile was optimized in terms of the peak lift, the duration, and the location for maximizing the fuel-efficiency potential of the strategy.

Influence of Valve Overlap Angle on GDI Engine Performance and Particulate Emission

Numerical Investigations of Injection Timing Effects on a GDI Engine Performance: Part B, In-Cylinder Emission Formation and Oxidation Process

Improving the Partial-Load Performance and Emission of GDI Engine by Combining Injection Strategy and Exhaust Variable Valve Timing Technology

Numerical Investigation of the Effect of Injection Timing on the In-Cylinder Activity of a Gasoline Direct Injection Engine

An Investigation and Evaluation of Variable-Valve-timing and Variable-Valve-actuation Strategies in a Diesel Homogeneous Charge Compression Ignition Engine Using Three-Dimensional Computational Fluid Dynamics

Effects of Variable Valve Timing on Diesel Fuel HCCI Combustion

Numerical Analysis of the Fuel Economy and Dynamic Performance of a GDI Engine Using EGR Coupled High Expansion Ratio Cycle

A Novel Valve Strategy for Particulate Matter Reduction in a Gasoline Direct Injection Engine Operated at Cold Conditions

Part-load Characteristics of Direct Injection Spark Ignition Engine Using Exhaust Gas Trap

Numerical Investigations of Injection Timing Effects on a Gasoline Direct Injection Engine Performance: Part A, In-Cylinder Combustion Process

Variable Valve Strategy Evaluation for Low-Load Operation in a Heavy-Duty Gasoline Compression Ignition Engine

Effect of the valve timing and the coolant temperature on particulate emissions from a gasoline direct-injection engine fuelled with gasoline and with a gasoline-ethanol blend

Effects of split and single injection strategies on particle number emission and combustion of a GDI engine

An Experimental Study on SICI Combustion in Gasoline Direct Injection Engine with Variable Valve Timing

Investigation of Injection Strategy on Combustion and Emission Characteristics in a GDI Engine with a 50 MPa Injection System

Numerical Investigation of the Influence of Intake Valve Lift Profile on A Diesel Premixed Charge Compression Ignition Engine with A Variable Valve Actuation System at Moderate Loads and Speeds

Cfd Analysis Of Vvt/Vva On The Gas Exchange And Fuel-Air Mixing In A Diesel Engine

Optimising the Particulate Emission Characteristics of a Dual-Fuel Spark Ignition Engine by Changing the Gasoline Direct Injection Strategy

Influences of Engine LIVC on Fuel Economy and Soot Emission

The Influence of Fuel Injection Timing on Exhaust Emission From a Diesel Engine

Improvement of Combustion Performance and Emissions in a Gasoline Direct Injection (GDI) Engine by Modulation of Fuel Volatility