Abstract:The rapid development of high-speed communication and radar systems has placed stringent requirements on the spectral purity of RF oscillators. Also, maximizing battery lifetime, efficiency, or power consumption is of great concern for these systems. The oscillator is thus required to have a low phase noise as well as a high figure-of-merit (FoM). Recently, to reduce the noise sensitivity of the LC oscillator, various harmonic shaping techniques [1] –[3]have been reported. By setting the differential-mode (DM) [1], [2] or common-mode (CM) [1], [3] resonances at specific harmonic frequencies, the impulse sensitive function (ISF) is reduced, and a high FoM could be achieved. However, to meet the strict relationship between fundamental frequency and resonances, the frequency tuning plan is complex, and the frequency range is limited. Besides, the minimum phase noise performance is still limited by the reduced power supply of advanced process and the maximum power taken by a single-core resonate tank. To overcome these limitations, the low-phase-noise oscillators have evolved from the single-core to multi-core types [4], [5]. By coupling N oscillators together, it is possible to burn N times higher power and decrease the phase noise by 10log(N), with the FoM unchanged. Nevertheless, the multi-core coupling method needs to be designed carefully to prevent concurrent oscillations [5]. Meanwhile, the conventional multi-core oscillators only achieve an average FoM of 189dB/Hz [4], [5], which is significantly worse than the state-of-the-art single-core oscillators. This paper proposes a distributed-boosting and harmonic-impedance-expanding multi-core oscillator, which can achieve low phase noise and high FoM simultaneously. A distributed-coupling transformer is introduced to obtain the distributed-boosting effect and maintain the coupling relationship of the four oscillator cores. The expanded DM and CM resonances are allocated for harmonic shaping over a wide frequency range. Prototyped in a conventional 40nm CMOS technology, the proposed oscillator operating at 3. 09GHz achieves the phase noise as low as -138.9dBc/Hz at 1MHz offset, 195.1dBc/Hz FoM, and 26.6% tuning range.

A 2.5-Ghz Low Phase Noise BAW-based Oscillator in 65nm CMOS Process

A 60GHz voltage-controlled oscillator with a 3.6GHz tuning range in 180nm CMOS technology

A Low Phase Noise VCO with Placement Reordered Cores and High-Q Bond Wire Array Inductors

A LOW POWER, LOW PHASE NOISE FBAR OSCILLATOR

A 0.8 V Low Power Low Phase-Noise Pll

An Ultra-Low-Voltage High-Performance VCO in 0.13 μm CMOS

A Compact Square-Geometry Quad-Core 19 GHz Class-F VCO with Parallel Inductor-sharing Technique achieving -137.2 dBc/Hz Phase Noise at 10MHz Offset

Low-phase-noise surface acoustic wave oscillator using phononic crystal bandgap-edge mode

A 76 GHz Oscillator by High-Q Differential Transmission Line Loaded with Split Ring Resonator in 65-Nm CMOS

A low phase noise oscillator using SIW combline resonator

An Ultra-Low Phase Noise 1.6ghz 65nm Class-B RF-VCO with -139.44Dbc/hz @1mhz Offset

A 3.09-to-4.04GHz Distributed-Boosting and Harmonic-Impedance-Expanding Multi-Core Oscillator with-138.9dBc/Hz at 1MHz Offset and 195.1dBc/Hz FoM

Low Phase Noise Oscillator Based on Quarter Mode Substrate Integrated Waveguide Technique.

A 20.7–31.8ghz Dual-Mode Voltage Waveform-Shaping Oscillator with 195.8dbc/hz FoMT in 28nm CMOS

A 1.9ghz Low-Phase-Noise Complementary Cross-Coupled FBAR-VCO Without Additional Voltage Headroom in 0.18µm CMOS Technology.

A SIW-based concurrent dual-band oscillator

A Low Power and Low In‐band Phase Noise W‐band Frequency Synthesizer in 65 Nm CMOS

An 8.2 GHz triple coupling low-phase-noise class-F QVCO in 65nm CMOS.

A Waveform-Shaping Millimeter-Wave Oscillator with 184.7dbc/hz FOM in 40nm Digital CMOS Process

A Class-C Eight-Phase Voltage-Controlled Oscillator With 184.2 dBc/Hz FoM and Loop-Based Superharmonic Coupling in 65nm CMOS

Design and Fabrication of Low Phase Noise Oscillator Using $Q$ Enhancement of the SISL Cavity Resonator