Abstract:This paper introduces a readout circuit structure tailored for high dynamic range CISs utilizing DCG imaging technology, using only one ADC for A/D conversion of HCG signals and LCG signals, which greatly reduces the area and power consumption of the readout circuit. Summary This paper introduces an area‐effective and low‐power readout circuit structure tailored for high dynamic range (HDR) CMOS image sensors (CISs) utilizing dual conversion gain (DCG) imaging technology. A switched capacitor amplifier, which is applied at the comparator input port of the column‐parallel single‐slope analog‐to‐digital converter (SS ADC), is proposed to compensate for the charge injection and clock feed‐through introduced when the pixel switches between high conversion gain (HCG) and low conversion gain (LCG) modes. The proposed SS ADC is supplemented by the integration of a configurable counter, and the counter is specifically crafted for performing the A/D conversion of the readout voltage within a DCG pixel. Compared to the conventional DCG readout circuit, the proposed readout circuit use only one ADC for A/D conversion of HCG signals and LCG signals, which greatly reduces the area and power consumption of the readout circuit. Simulation results under 110 nm CMOS technology illustrate that the proposed 10‐bit SS ADC has a DNL of +0.78/−0.91 LSB and an INL of +1.91/−1.69 LSB, with a SNR of 57.2 dB and a SNDR of 55.95 dB, corresponding to an ENOB of 9 bits. The power consumption of the proposed SS ADC is 56.4 μW per column with a conversion time of 12 μs, and the simulation results show that the power consumption is 23.35% lower than the conventional structure and the area is saved by 24.69%.

Two Ramp Reference Voltages CDS Scheme Applied to Low Noise and High Dynamic Range PWM Pixel

A High Efficiency Step-Up WLED Driver with Wide Range PWM Dimming

A 153μw 26nv/√hz Readout Circuit with BW and Power Scalability Using Capacitively-Coupled Chopper Floating Inverter Amplifier Embedded in a Discrete-Time ΔΣ Modulator

An improved pixel circuit with low noise event rate and enhanced bright‐light sensitivity for dynamic vision sensor

Design of a Pixel Readout ASIC Using Super Pixel Circuits with a Built-in LDO Regulator for Hybrid X-ray Imaging Detectors

High Consistency Ramp Design Method for Low Noise Column Level Readout Chain

A 3-Transistor CMOS Active Pixel with In-Pixel Correlated Double Sampling

A Single Slope ADC with Row-Wise Noise Reduction Technique for CMOS Image Sensor

A High Load Current, Low-Noise, Area-Efficient, Full On-Chip Regulator for Cmos Pixel Sensors

Optimizing techniques for charge injection effect of pixels in CMOS image sensor

A Single-Slope PWM Imaging Method for Multi-Mode Dynamic Vision Sensor

A Low Noise Reference Generator in Monolithic Active Pixel Sensors for Star

Two-Step Single-Slope ADC Utilizing Differential Ramps for CMOS Image Sensors

A Low-Noise CMOS Image Sensor With Digital Correlated Multiple Sampling

Correlated double sample design for CMOS image readout IC

An area‐effective and low‐power single‐slope ADC for DCG imaging CMOS image sensor

Pixel-level A/D Conversion Using Voltage Reset Technique

A digital CDS technique and the performance testing

Low-light-level CMOS imaging sensor with CTIA and digital correlated double sampling

A Digital Cds Technique and Its Performance Testing

A high consistency ramp circuit design method for negative feedback adaptive adjustment mechanism applied to large area array CMOS image sensors