Abstract:The application requirements of high frame rate CMOS image sensors (CIS) in the industry have not been satisfied due to the speed limitations in traditional single-slope and serial two-step analog-to-digital converters (ADCs). In this paper, a high-speed fully differential two-step ADC design method for CIS was proposed. The proposed method was based on differential ramp and time-to-digital conversion (TDC) technology. A parallel conversion mode was formed that is different from serial conversion, and the robustness of the system was ensured due to the existence of differential ramps. Aiming at the inconsistency between traditional TDC technology and single-slope ADC, a TDC technology based on level coding was proposed. The proposed technology achieves the TDC in the last clock cycle of analog-to-digital conversion, and realized a two-step conversion process at another level. This paper presents a complete circuit design, layout design, and test verification of the proposed design method based on the 55 nm 1P4M CMOS experimental platform. Under the design environment of the analog voltage of 3.3 V, the digital voltage of 1.2 V, the clock frequency of 100 MHz, and a dynamic input range of 1.6 V, this design was a 12-bit ADC with a conversion time of 480 ns, column-level power consumption of 62 μW, differential nonlinearity (DNL) of +0.6/−0.6 LSB, and integral nonlinearity (INL) of +1.2/−1.4 LSB. Furthermore, it achieved a signal-to-noise distortion ratio (SNDR) of 70.08 dB. The proposed design provided a large area array with a high frame rate, and compared with the existing advanced single-slope ADC, its conversion speed increased by more than 52%. It provides an effective solution for the implementation of high frame frequency CIS.

An Intrascene Wide Dynamic Range CMOS Image Sensor Using Dual-Gain Ramp Generator for Machine Vision Applications

A Reconfigurable Convolution-in-Pixel CMOS Image Sensor Architecture

A Near-array Convolution Computing Scheme Based on WSe<sub>2</sub> Photodiode

An Arithmetic of Enhancing Dynamic Range of CMOS Image Sensor

A 14-bit 150KS/s SAR ADC with PGA for CMOS Image Sensor

14-Bit Column Readout Circuits with Single-to-differential PGA Using Intentional Offset and Two-Step Scaled-Reference SAR ADC for CMOS Image Sensors

An Over 90 dB Intra-Scene Single-Exposure Dynamic Range CMOS Image Sensor Using a 3.0 μm Triple-Gain Pixel Fabricated in a Standard BSI Process

High-Speed Fully Differential Two-Step ADC Design Method for CMOS Image Sensor

An area‐effective and low‐power single‐slope ADC for DCG imaging CMOS image sensor

An Over 140 dB Dynamic Range CMOS Image Sensor Combined DCG and Logarithmic Response

A High Full Well Capacity CMOS Image Sensor for Space Applications

On-CMOS Image Sensor Processing for Lane Detection

Novel CMOS image sensor with a 132-dB dynamic range

A 1/2.5 Inch Vga 400 Fps Cmos Image Sensor with High Sensitivity for Machine Vision

Circuit Design of High-Dynamic-Range Image Sensor Pixel for Visual Prostheses

A 51-Pj/pixel 33.7-Db PSNR 4× Compressive CMOS Image Sensor with Column-Parallel Single-Shot Compressive Sensing

A Dual-Mode CMOS Image Sensor Based on In-Pixel Frame Differencing

A Three-Wafer-Stacked Hybrid 15-MPixel CIS + 1-MPixel EVS With 4.6-GEvent/s Readout, In-Pixel TDC, and On-Chip ISP and ESP Function

Two-Step Single-Slope ADC Utilizing Differential Ramps for CMOS Image Sensors

High Performance CMOS Image Sensor for Low Light Imaging

320×240 Pixels CMOS Digital Image Sensor with Wide Dynamic Range