Abstract:Distributed fiber-optic sensing (DFOS) technologies have been used for decades to detect damage in infrastructure. One recent DFOS technology, Optical Frequency Domain Reflectometry (OFDR), has attracted attention from the structural engineering community because its high spatial resolution and refined accuracy could enable new monitoring possibilities and new insight regarding the behavior of reinforced concrete (RC) structures. The current research project explores the ability and potential of OFDR to measure distributed strain in RC structures through laboratory tests on an innovative beam–column connection, in which a partial slot joint was introduced between the beam and the column to control damage. In the test specimen, fiber-optic cables were embedded in both the steel reinforcement and concrete. The specimen was tested under quasi-static cyclic loading with increasing displacement demand at the structural laboratory of the Pacific Earthquake Engineering Research (PEER) Center of UC Berkeley. Different types of fiber-optic cables were embedded both in the concrete and the rebar. The influence of the cable coating and cable position are discussed. The DFOS results are compared with traditional measurements (DIC and LVDT). The high resolution of DFOS at small deformations provides new insights regarding the mechanical behavior of the slotted RC beam–column connection, including direct measurement of beam curvature, rebar deformation, and slot opening and closing. A major contribution of this work is the quantification of the performance and limitations of the DFOS system under large cyclic strains. Performance is quantified in terms of non-valid points (which occur in large strains when the DFOS analyzer does not return a strain value), maximum strain that can be reliably measured, crack width that causes cable rupture, and the effect of the cable coating on the measurements. Structural damage indices are also proposed based on the DFOS results. These damage indices correlate reasonably well with the maximum sustained drift, indicating the potential of using DFOS for RC structural damage assessment. The experimental data set is made publicly available.

Calculation the Opening of Neighboring Surface Cracks in Concrete Structure Based on OFDR Technology

Crack monitoring on concrete structures with distributed fiber optic sensors—Toward automated data evaluation and assessment

Towards an Automated Crack Monitoring using Distributed Fiber Optic Sensors

Crack width measurement with OFDR distributed fiber optic sensors considering strain redistribution after structure cracking

Experimental Research on Monitoring Concrete Expansion and Cracking Induced by Corrosion based on Distributed Optical Fiber Sensor

Theoretical and Experimental Investigation into Detection of Early-Stage Propagation of Double Cracks with Distributed Fiber Optic Sensor

Prediction of Crack Opening in Steel Beam Based on Strains Measured from Distributed Optical Fiber Sensor

Experimental Research on Corrosion-Induced Cracking Monitoring Based on Optical Fiber Sensor

Monitoring of crack opening displacement of steel structure by PPP-BOTDA-distributed fiber optical sensors: Theory and experiment

Embedded Distributed Optical Fiber Sensors in Reinforced Concrete Structures—A Case Study

Distributed Fiber-Optic Strain Sensing of an Innovative Reinforced Concrete Beam–Column Connection

Distributed cracks detection by BOTDA and its application in corrosion cracking monitoring

Brillouin scattering spectrum-based crack measurement using distributed fiber optic sensing

Distributed fiber optic strain sensing for crack detection with Brillouin shift spectrum back analysis

Experimental Research on Concrete Crack Recognizing and Monitoring Based on Distributed Fiber Sensor

Experimental and Numerical Investigation into Corrosion-Induced Mortar/concrete Cracking with Distributed Optical Fiber Sensors

On using the DFOS for damage identification in civil engineering structures

Localization and Monitoring of Initiation and Propagation of Corrosion-Induced Mortar Cracking Based on OFDR Distributed Optical Fiber Sensor

Fiber optic sensing of concrete cracking and rebar deformation using several types of cable

An Experimental Investigation on Continuous Strain and Crack Monitoring with Fiber Optic Sensors

Performance of A Botdr Optical Fibre Sensing Technique for Crack Detection in Concrete Structures