Abstract:A mathematical model of biomass ash deposition based on inertial impaction, thermophoresis deposition, and condensation was established to predict the ash deposition on the heating surface in a biomass boiler. Compared with the conventional numerical simulation methods, the mathematical models established are more focused on important design parameters in industry and can quickly calculate changes in parameters such as ash and heat flux density of heating area, and the simulated values were in good agreement with the measured results of the actual boiler. The growth of ash deposition on the heating surface of the boiler under different operating conditions was calculated by MATLAB program. The results show that the deposition caused by inertial impaction is dominant among the three deposition mechanisms. While the deposition caused by condensation is the least, accounting for only about 1%. The heat flux is only 1/2 of the initial stage when the ash deposition reaches a steady state. The ash deposition degree increases with the increasing of flue gas velocity, flue gas temperature, and particle size. When the flue gas temperature increases from 923 K to 1123 K, the ash deposition thickness increases from 7.6 mm to 14.2 mm. When the particle size increases from 12 mu m to 20 mu m, the thickness of ash deposition increases from 5.3 mm to 10.7 mm; when the gas velocity increased from 6 m/s to 15 m/s, the thickness of ash deposition increased from 6.5 mm to 10.6 mm. The ash depositions in two corn stalk-fired pure-combustion circulating fluidized bed (CFB) boilers were calculated, and the predicted results of the model were consistent with the actual ash deposition level.

Study on dynamic bed temperature model of biomass circulating fluidized bed boiler

Integrated modeling of bed temperature for a circulating fluidized bed incinerator

The Study of Unified Thermal Calculation Model of Circulating Fluidized Bed Boiler Based on Experience

Study on Dynamic Behavior of the Combustion System of a Circulating Fluidized Bed Boiler

Modeling and Prediction of Biomass Direct Fired Circulating Fluidized Bed Boiler Combustion System

Dynamic Modeling and Simulation of CFB Boiler

Study on the dynamic balance behaviors of bed material during the start-up process of a circulating fluidized bed boiler

Research for Control Model about CFBB Coal-bed Temperature

Research of Relationship Between CFBB Dynamic Behavior and Power and Coal Quality

Research on control system of 600 MW supercritical circulating fluidized bed boiler

Modeling Approach for the Biomass-Fuelled Circulating Fluidized Bed Boiler

Heat Transfer Coefficient Calculation of a Circulating Fluidized Bed Boiler for Different Operating Modes

Study on Dynamic Characteristics of Residual Char of CFB Boiler Based on CPFD Method

Ash Deposition Characteristics on Heating Surface in Biomass Circulating Fluidized Bed Boiler

STUDY ON DYNAMIC MATHEMATICAL MODEL AND SIMULATION OF CFB BOILER

Measurement of Heat Transfer in a 465t/h Circulating Fluidized Bed Boiler

Bed Temperature Control Characteristics of CFB Boilers

Study on Nonlinear Control Model of Supercritical (Ultra Supercritical) Circulating Fluidized Bed Unit

Effect of the Circulating Loop Performance on the Bed Temperature of a Circulating Fluidized Bed Boiler

Modeling Study of a New Circulating Fluidized Bi-Bed Boiler Combustion System

Development of Biomass-Fired Circulating Fluidized Bed Boiler with High Steam Parameters Based on Theoretical Analysis and Industrial Practices