Abstract:A detailed numerical simulation of forced convection heat transfer occurring in silicon-based microchannel heat sinks has been conducted using a simplified three-dimensional conjugate heat transfer model (2D fluid flow and 3D heat transfer). The micro-heat sink model consists of a 10 mm long silicon substrate, with rectangular microchannels, 57 μm wide and 180 μm deep, fabricated along the entire length. A finite difference numerical code with a Tri-Diagonal Matrix Algorithm (TDMA) was developed to solve the governing equations. The validated code provided detailed temperature and heat flux distributions in the microchannel heat sink. The influence of the geometric parameters of the channel and the thermophysical properties of the fluid on the flow and heat transfer, are investigated by evaluating thermophysical properties at a reference bulk temperature. The results indicate that thermophysical properties of the liquid can significantly influence both the flow and heat transfer in the microchannel heat sink. The bulk liquid temperature is shown to vary in a quasi-linear form along the flow direction for high fluid flow rates, but not for low flow rates. Comparison of the numerical results with other published numerical results and experimental data available in the literature for Reynolds numbers less than 200 based on a hydraulic diameter of Dh=86 μm and Dh/Lx<0.01, indicates that the assumption of hydrodynamic, fully developed laminar flow is valid. The thermal entrance length is also obtained from the detailed local heat transfer coefficient calculation and a correlation for the overall averaged Nusselt number is developed and discussed. Finally, a methodology is proposed whereby measured data can be evaluated and processed in order to provide a more complete understanding and better interpretation of these experimental data.

3D-FEM Thermal Transfer Analysis of MEMS-based Thermal Infrared Emitter Integrated with Microchannel Heatsink

3D-FEM Electrical–thermal–mechanical Analysis and Experiment of Si-based MEMS Infrared Emitters

Reliability Design and Electro-Thermal-Optical Simulation of Bridge-Style Infrared Thermal Emitters.

Three-dimensional thermal analysis of rectangular micro-scale inorganic light-emitting diodes integrated with human skin

A numerical investigation of conjugate forced heat transfer for a micro thermal flow sensor

Numerical Simulation of MEMS Micro Thermal Sensor

A Comprehensive Study of a Micro-Channel Heat Sink Using Integrated Thin-Film Temperature Sensors.

Three-dimensional analysis of heat transfer in a micro-heat sink with single phase flow

Enhanced Flow Boiling Heat Transfer with Three-section Sudden Expansion Microchannels

Simulation and Design of a Hot-Film Air Flow Sensor with Sapphire As Substrate

Analysis of Heat Transfer Performance about Microchannel Heat Sinks Using FEM

A Three-Dimensional Integrated Micro Calorimetric Flow Sensor in CMOS MEMS Technology

Numerical study of the thermal performance of a novel microchannel heat sink

Heat‐flux‐specified Boundary Treatment for Gas Flow and Heat Transfer in Microchannel Using Direct Simulation Monte Carlo Method

Performance Enhance of CMOS-MEMS Thermoelectric Infrared Sensor by Using Sensing Material and Structure Design

Experimental and Numerical Investigation on Thermal Characteristics of the Heat Sink Integrating 3D Vapor Chamber Heat Spreader and Liquid Cooling Fins

Numerical study on the thermal performance of microchannel heat sink with composite elliptical pin fin

Numerical Study of the Thermal Thermopile Flow Sensor

An Experimental Study on the Thermosiphon Loop with a Microchannel Heat Sink Operating with the Phase Change Emulsion

Infrared Thermal Velocimetry in Mems-Based Fluidic Devices

A Novel Heat Transfer Characterization Method for a Thermal Management Scheme of 3D-Ic Chips