Abstract:In this paper, we present a broadband out-of-phase power divider with high power-handling capability. The proposed device consists of several sections of double-sided parallel-strip lines (DSPSLs), a mid-inserted conductor plane, and two external isolation resistors, which are directly grounded for heat sinking. A through ground via (TGV), connecting the top and bottom sides of DSPSLs, is employed. The special metal via is realized to short the isolation resistors at full-frequency band when the odd-mode is excited. Meanwhile, it can be ignored as the excitation is even-mode. This property is efficiently utilized to improve the bandwidth. To examine the proposed power divider in detail, a set of closed-form equations are derived. Meanwhile, the power operation analysis illustrates that the proposed power divider is a good candidate for high power applications. The design charts show that the proposed device can support a wide frequency ratio range (1-1.7). Furthermore, broadband responses can be obtained when proper frequency ratios are adopted. For verification, an experimental power divider operating at 1.25/1.75 GHz is implemented. The measured results exhibit a bandwidth of 44.3% with better than 15 dB return loss and 18 dB port isolation is achieved.

An Isolated Waveguide Divider for W-Band Power Combined Amplifier

Two-Way Current-Combining -Band Power Amplifier in 65-nm CMOS

W-band Power Divider Based on H-plane Slot Waveguide Bridge

A W-band current combined power amplifier with 14.8dBm Psat and 9.4% maximum PAE in 65nm CMOS

A High-Efficiency W-Band Power Combiner Based on the TM01 Mode in a Circular Waveguide

A W-Band E-Plane Waveguide In-Phase Power Divider with Full Bandwidth and High Isolation

A Broadband Waveguide-Based Power Divider in W-band

W-BAND SIW POWER COMBINER/DIVIDER BASED ON THE ANTIPODAL FIN-LINE SIW-RW TRANSITION AND LONGITUDINAL-SLOT COUPLING TECHNIQUES

An Isolated Three-Way Power Combiner via Magnetically Coupled Microstrip Ring Probes

An Isolated Out-of-Phase 3-dB Power Divider via Waveguide-to-Microstrip Transition

Four-way power divider/combiner based on waveguide-microstrip structure in W-band

A Design of Wide-Band and High-Isolation Power Divider

A compact four-way power combiner/divider in W-Band

Four-way Waveguide Power Divider Design for W-band Applications

Design of a High Isolation F-band E-plane Waveguide Power Divider

A Waveguide-Based Spatial Power Combining Module at Higher Millimeter-Wave Frequency

All-Metal-Waveguide Power Divider with High Power-Combining Efficiency

A Novel E-plane T-junction Power Divider with Ultra-wideband and High Isolation

Millileter-Wave Power-Combining Amplifier Using A Broadband Waveguide Combiner

A BROADBAND OUT-OF-PHASE POWER DIVIDER FOR HIGH POWER APPLICATIONS USING THROUGH GROUND VIA (TGV)

Compact coaxial-waveguide four-way power divider with low insertion loss and high output isolation