Structure and Process Optimization for Highly‐Efficient Membrane Capacitive Deionization

Dongya Ma,Yu Wang
DOI: https://doi.org/10.1002/ente.202001077
IF: 4.149
2021-02-24
Energy Technology
Abstract:<p>To achieve a fluid uniform distribution, novel liquid distributors were introduced into the MCDI cell. Here were proposed three fluid distributors with different structures, primarily including flow channels and distributed baffles. Also, the effects of each liquid distributor on the fluid distribution were evaluated through CFD software. As a result, the Liquid distributor‐3 was demonstrated to be optimal, which can facilitate the fluid uniform distribution and relieve the impact of inlet flow rate on the fluid distribution. Correspondingly, the adsorption capacity reached up to 23.8 mg·g<sup>−1</sup> for this novel MCDI cell under the 2000 mg·L<sup>−1</sup> NaCl solution. To find a trade‐off between desalination performance and energy‐efficient, a modified MCDI system based on two novel MCDI cells and three valves was established by analyzing three adsorption/desorption processes, including Process 1 (both adsorption and desorption in parallel), Process 2 (adsorption in series and desorption in parallel) and Process 3 (both adsorption and desorption in series). The best performance was obtained by Process 1, where the current efficiency increased by about 25% in adsorption process and by about 37% during desorption process compared with Process 3. This study lays a foundation for the commercial application of multi‐component MCDI technology.</p><p>This article is protected by copyright. All rights reserved.</p>
energy & fuels
What problem does this paper attempt to address?