Abstract:The new concept of sewer mining which utilizes the ceramic nanofiltration (C-NF) membranes offers a compact solution for water and other resources recovery. However, since it has very limited pre-treatment process, membrane fouling is a common problem due to the direct contact between the membrane and sewage water. Sewage water contains a lot of extracellular polymeric substances (EPS) that can block the membrane pores. One of the most persistent EPS is sodium alginate which responsible for the gel layer formation on the membrane surface. Removal of the alginate gel layer can be done by implementing chemical cleaning. However, too frequent chemical cleaning can damage the membrane and environmentally dangerous. Therefore, to make this new concept of sewer mining more feasible, the correct cleaning method to remove the fouling layer need to be found. From this point, the research objective for this research is formulated as “Investigation of fouling control methods that can prolong the time before chemical cleaning needs to be performed to achieve higher water production.” Several methods such as forward flush, iron coating and calcium carbonate coating were investigated. Alginate filtration was done under constant pressure experiment and the effectivity of each cleaning method was calculated by measuring the change in water permeability after the cleaning. The results show that the iron and calcium carbonate coating followed by 5 min forward flush are able to achieve a permeability recovery of 40 to 90 %. Iron coating required 400 mg/l of iron hydroxide to be dossed and a minimum of 5 min reaction times with hydrogen peroxide to have a high permeability recovery. On the other hand, only 1 minute is required by 200 mg/l calcium carbonate dosing concentration with citric acid as a cleaning solution to achieve a similar improvement as the iron hydroxide coating. Both of the processes produce higher water productivity in 2 h of experiment than the chemical cleaning with 0.1 % sodium hypochlorite. In the end, a theoretical projection on the real sewage water filtration was made to study the economic and environmental impact of the coating process. The results show the cost of production per m3 of clean water is 0.22 euro for iron hydroxide and only 0.12 euro for calcium carbonate. Furthermore, environmental impact assessment using Chain Management by Life Cycle Analysis (CMLCA) software which produced by Leiden University with Eco-indicator 99 (EI-99) categorization shows that calcium carbonate has less environmental burden than iron hydroxide coating.

Membrane Fouling of Pressure Retarded Osmosis with CO2-captured Alkali Solutions As Draw Solutions

Membrane Performance of Pressure-Retarded Osmosis Using Simulated Hydroxide-Based CO2-captured Draw Solutions

Membrane performance of pressure-retarded osmosis using simulated hydroxide-based CO 2 -captured draw solutions

Fouling Behaviours and Mitigation in Pressure-Retarded Osmosis Processes with Geothermal Water/brine-Based Draw Solutions

Understanding the performance of membrane for direct air capture of CO2

Direct CO 2 mineralization using seawater reverse osmosis brine facilitated by hollow fiber membrane contactor

Membrane fouling and anti-fouling strategies using RO retentate from a municipal water recycling plant as the feed for osmotic power generation

Fouling Control in Ceramic Nanofiltration Membrane: Forward Flush and Precoating Method

Bipolar membrane electrodialysis integrated with in-situ CO2 absorption for simulated seawater concentrate utilization, carbon storage and production of sodium carbonate

Advanced Anti-Fouling Membranes for Osmotic Power Generation from Wastewater via Pressure Retarded Osmosis (PRO)

Electro mitigation of calcium carbonate and calcium sulfate scaling in an optimized thermal conductive membrane distillation process

Reverse osmosis membrane autopsy in coal chemical wastewater treatment: Evidences of spatially heterogeneous fouling and organic-inorganic synergistic effect

Dynamic relationship between membrane fouling and reverse diffusion of inorganic draw solutes in forward osmosis

Continuous Process of Biogas Purification and Co-Production of Nano Calcium Carbonate in Multistage Membrane Reactors

Effect of ferrous-activated calcium peroxide oxidation on forward osmosis treatment of algae-laden water: Membrane fouling mitigation and mechanism

Proof of concept: Integrated membrane distillation-forward osmosis approaches water production in a low-temperature CO2 capture

Calcium carbonate scaling and seeding induced precipitation in FO treating textile reverse osmosis concentrate

Formation of Organic Fouling during Membrane Desalination: The Effect of Divalent Cations and the Use of an Online Visual Monitoring Method

Design of Anti-Fouling Membrane Coatings for Desalination

Fouling of reverse osmosis membrane in sugar mill condensate purification under sub- and super-boundary flux conditions

Fouling Characteristics and Fouling Control of Reverse Osmosis Membranes for Desalination of Dyeing Wastewater with High Chemical Oxygen Demand