Abstract:This study explored the effect of pre-corrosion damage on the tribology behavior of the austenitized and the different tempered conditions of 13 wt.% Cr martensitic stainless steel under dry sliding conditions using a "ball on plate" configuration. Corrosion immersion experiments were performed in 5 wt.% HNO 3 solution at room temperature for 30 min. The austenitized and the tempered at 300 °C (T300) specimens displayed the attack along the prior austenitic grain boundaries, whereas the specimens tempered at 550 (T550) and 700 °C (T700) showed intergranular plus interlath corrosion and uniform corrosion, respectively. Subjecting this corrosion-damaged specimens to dry sliding revealed non-monotonic friction and wear behavior with tempering temperature. The microstructure and the type of corrosion attack together determined the overall wear performance of the tempered conditions. The specific wear rate ( k ) decreased in the order k T700 > k T550 > k T300 ~ k austenitized . The k value of the austenitized and the T300 specimens (~ 32 − 35 × 10 −6 mm 3 /Nm) is observed to be 12 and 15 times lower than the k value of T550 (~ 408 × 10 −6 mm 3 /Nm) and T700 (~ 495 × 10 −6 mm 3 /Nm) specimens, respectively. The reason for the lower k value is due to the continuous, thick (~ 4 μ m thickness) Cr-rich tribo-film that formed on the wear track and acted as solid lubricant. The T550 and T700 specimens had a discontinuous Fe-rich tribo-film on the wear tracks; therefore, rubbing in the presence of harder and loose Fe-rich oxides particles led to severe adhesion plus galling in T550 and smearing plus plastic deformation in T700 specimens. It was also found that the wear rate and surface damage are reduced for pre-corroded austenitized and T300 specimens compared to the respective unattacked pristine specimens; however, the opposite effect was observed in T550 and T700 specimens.

Effect of frictional frequency on the subsurface evolution of 316L stainless steel in tribocorrosion and its influence on the synergistic effect between corrosion and wear

Tribocorrosion investigation of 316L stainless steel: the synergistic effect between chloride ion and sulfate ion

Effects of surface deformation on corrosive wear of stainless steel in sulfuric acid solution

Corrosion and Tribocorrosion Behaviors of AISI 316 Stainless Steel and Ti6Al4V Alloys in Artificial Seawater

Synergism Between Wear and Corrosion of Cr26Mo1 Ferrite Stainless Steels in 0.5 mol/L of Sulfuric Acid

Tribocorrosion properties of AISI 1045 and AISI 2205 steels in seawater: Synergistic interactions of wear and corrosion

Effects of Different Cathodic Reactions on Tribocorrosion Behavior of AISI 430 in 0.5 mol/L Sulfuric Acid

Friction and Wear Mechanisms of 316L Stainless Steel in Dry Sliding Contact: Effect of Abrasive Particle Size

Antagonistic effect of electrochemical corrosion on the mechanical wear of Monel 400 alloy in seawater

Effect of the Frequency on Fretting Corrosion Behavior Between Alloy 690TT Tube and 405 Stainless Steel Plate in High Temperature Pressurized Water

Effect of Micro-Textured Surfaces and Sliding Speed on the Lubrication Mechanism and Friction-Wear Characteristics of CF/PEEK Rubbing against 316L Stainless Steel under Seawater Lubrication

Tribocorrosive Aspects of Tungsten Carbide, Silicon Nitride, and Martensitic Steel under Fretting-like Conditions

Effect of polarization potential on the corrosive wear and friction behavior of a duplex stainless steel in the sulfuric acid solution

Effect of surface oxidation on wear and tribocorrosion behavior of forged and selective laser melting-based TC4 alloys

Effect of Pre-corrosion Damage on Dry Sliding Wear Behavior of Differently Heat-Treated Martensitic Stainless Steel

The Study of Micro-grating and Micro-square-column on Frictional Resistance Reduction of 316L Stainless Steel Surface

Effect of Nanosecond Laser Texturization on Tribological Behavior of AISI 321 Stainless Steel

EFFECT OF MICRO-TEXTURES AND CrAlSiN COATINGS ON THE FRICTION AND WEAR PROPERTIES OF 316L STAINLESS STEELS IN SEAWATER

Mild corrosion behavior on sulphurized steel surface during friction

Effect of heat treatment on the tribocorrosion behavior of 20Cr13 martensitic stainless steel

Effect of Rotational Velocity on Mechanical and Corrosion Properties of Friction Stir-Welded SUS301L Stainless Steel