Abstract:Compression plates are widely used in orthopaedic surgeries for internal fixation of fractured femurs. To fix the plate and thus to provide compression to a fracture, the self-tapping bone screws are tightened through predrilled pilot holes of smaller diameter. Preliminary investigation showed that the holes drilled with the inappropriate cutting parameters cause mechanical and thermal damages to the local host bone, which further lead to loosening of internal fixations. In this paper, the mechanistic models to predict the thrust forces and torques during bone drilling were developed, using a 3.20 mm diameter drill bit. As a procedure, the cutting action was investigated at three different regions of the drill point, namely cutting lips, secondary cutting edges and indentation zone. The models employed the analytical approach to account for the drill-bit geometry and cutting parameters, and an empirical approach to account for the material and friction properties. To complete the procedure, calibration experiments were conducted on bovine cortical femurs with two different spindle speeds (1000 and 3000 r/min) and feeds (0.03 and 0.06 mm/rev), and then the specific normal and friction coefficients were determined. The developed mechanistic models were validated with different ranges of parameters (500–3500 r/min speeds, and 0.02–0.07 mm/rev feeds) those commonly involved in manual and robot-assisted surgery. The validation study revealed that the thrust forces predicted using the mechanistic models showed a maximum error of only 5.80%. However, the torques predicted from the mechanistic model found with more error than the thrust forces. The predominant reasons for this under-prediction might because of the extrapolation used to determine the specific cutting pressures, slip-line field applied to the indentation zone instead of compressive fracture, and chip clogging involved during the bone drilling as demonstrated in earlier studies. Despite the deviations, the developed mechanistic models satisfactorily follow the trends of the thrust forces and torques experienced during bone drilling. The outcomes can be used to practice the bone drilling procedure and monitor the effect of process parameters on thrust forces and torques in the in-silico environment before performing actual surgery.

Force Prediction and Analysis in Surgical Sawing of Composite Bone Involving Multi-Tooth Reciprocating and Heterogeneous Pore Model

Modeling and Analysis of Force Prediction in Milling Process of Unidirectional Fiber Reinforced Polymer Composites

Dynamic Cutting Force Modeling and Experimental Study of Industrial Robotic Boring

Serrated chip formation mechanism in orthogonal cutting of cortical bone at small depths of cut

Material Removal Mechanism and Force Modeling in Ultrasonic Vibration-Assisted Micro-Grinding Biological Bone

A cortical bone milling force model based on orthogonal cutting distribution method

Experimental and Finite Element Analysis of Force and Temperature in Ultrasonic Vibration Assisted Bone Cutting

Testosterone 5 alpha-reductase in spinal cord of Xenopus laevis.

Cutting Behavior of Cortical Bone in Different Bone Osteon Cutting Angles and Depths of Cut

Research on ultrasonic bone cutting mechanism based on extended finite element method

Mechanistic models to predict thrust force and torque in bone drilling: An in-vitro study validated with robot-assisted surgical drilling parameters

[A new method of ureter substitution in animal experiment. Preliminary report].

3D Printing and Computer-Aided Design for Precision Osteotomy-Aided Modules in Bone Biomechanical Study

Model-based biomechanical dental implant optimization in bone-implant system

Micro-FEM Orthogonal Cutting Model for Bone Using Microscope Images Enhanced Via Artificial Intelligence

Influence of Mechanical Factors on the Cutting Performance of an Ultrasonic Bone Scalpel

A Morphing Machining Strategy for Artificial Bone

Prediction of surface roughness and cutting force induced during rotary ultrasonic bone drilling via statistical and machine learning algorithms

Bone Layer Proportion Recognition and Cutting Depth Control Based on Intraoperative Signal Processing in Robotic Laminectomy

Multi-objective optimization of cortical bone grinding parameters based on particle swarm optimization

A normal force model for ultrasonic vibration-assisted inner-diameter slicing of hard and brittle materials