Abstract:The current study aims to evaluate the performance of the ultrasonic vibration-assisted milling (USVAM) process when machining two different materials with high deviations in mechanical properties, specifically 7075 aluminium alloy and Ti-6Al-4V titanium alloy. Additionally, this study seeks to develop an AI-based model to predict the process performance based on experimental data for the different workpiece characteristics. In this regard, an ultrasonic vibratory setup was designed to provide vibration oscillations at 28 kHz frequency and 8 μm amplitude in the cutting feed direction for the two characterised materials of 7075 aluminium alloy (150 BHN) and Ti-6Al-4V titanium alloy (350 BHN) workpieces. A series of slotting experiments were conducted using both conventional milling (CM) and USVAM techniques. The axial cutting force and machined slot surface roughness were evaluated for each method. Subsequently, Support Vector Regression (SVR) and artificial neural network (ANN) models were built, tested and compared. AI-based models were developed to analyse the experimental results and predict the process performance for both workpieces. The experiments demonstrated a significant reduction in cutting force by up to 30% and an improvement in surface roughness by approximately four times when using USVAM compared to CM for both materials. Validated by the experimental findings, the ANN model accurately and better predicted the performance metrics with RMSE = 0.11 μm and 0.12 N for Al surface roughness and cutting force. Regarding Ti, surface roughness and cutting force were predicted with RMSE of 0.12 μm and 0.14 N, respectively. The results indicate that USVAM significantly enhances milling performance in terms of a reduced cutting force and improved surface roughness for both 7075 aluminium alloy and Ti-6Al-4V titanium alloy. The ANN model proved to be an effective tool for predicting the outcomes of the USVAM process, offering valuable insights for optimising milling operations across different materials.

Sensitivity of acoustic emission signals features to cutting parameters in time domain: case of milling aeronautical aluminium alloys

In situ monitoring of FDM machine condition via acoustic emission

An effective sensor for tool wear monitoring in face milling: Acoustic emission

Experimental Investigation of Correlation Between Attrition Wear and Features of Acoustic Emission Signals in Single-Grit Grinding

Real-time FDM Machine Condition Monitoring and Diagnosis Based on Acoustic Emission and Hidden Semi-Markov Model

Multiparameter signal-to-noise ratio optimization for end milling cutting conditions of aluminium alloy 5083

A brief review: acoustic emission method for tool wear monitoring during turning

In Situ Measurement of the Machining State in Small-Diameter Drilling by Acoustic Emission Sensing

Analysis of Spindle AE Signals and Development of AE-Based Tool Wear Monitoring System in Micro-Milling

Process parameters influence on cutting force and surface roughness during hybrid laser- and ultrasonic elliptical vibration-assisted machining

Machine learning coupled with acoustic emission signal features for tool wear estimation during ultrasonic machining of Inconel 718

Identification of AE Signal for Tool Breakage Monitoring Based on EEMD

Optimizing tool life in SiCp/Al composites milling with acoustic emission analysis: A comprehensive monitoring and implementation strategy

Identification of tool wear using acoustic emission signal and machine learning methods

Material recognition for fault diagnosis in machine tools using improved Mel Frequency Cepstral Coefficients

Application of acoustic emission signal in grinding difficult-to-machine materials

Effects of machining parameters on spectral entropy of acoustic emission signals in the electro erosion

Detection of Tool Breakage During Milling Process Through Acoustic Emission

AI-Based Prediction of Ultrasonic Vibration-Assisted Milling Performance

End Milling Tool Breakage Detection Using Lifting Scheme and Mahalanobis Distance

Acoustic emission monitoring for necking in sheet metal forming