Abstract:This article proposes a fault-tolerant control method for an input-parallel–output-series (IPOS) converter under open-circuit switch failure, which mainly focuses on two parts: fault diagnosis (fault detection and fault identification) and remedial action. The fault diagnosis is realized based on immersion and invariant observer (I&IO), which has strong robustness to parameter uncertainty and external disturbances, and therefore, it can be designed using only the crude converter model with nominal parameters. Moreover, the sampling frequency required by the fault diagnosis is the same as the frequency required by the system controller. Thus, the fault diagnosis module can be easily embedded in the well-designed power system without extra sensors. Based on the method, the open-circuit fault in power switches can be detected and identified within two switching periods. As for remedial action, two redundant switches are needed for postfault reconfiguration. Also, the remedial action can be immediately triggered after the switch failure is detected. To reduce the complexity of remedial action, the same postfault reconfiguration will be carried out for the open-circuit failure in different switches. Besides, system controllers are also carefully designed to guarantee the performance of the postfault converter. Both simulations and experiments are conducted for the validations, and the results have shown the effectiveness, robustness, and rapidity of the proposed method.

A Switching Oscillation Event-Triggered Switch Fault Detection Method for SiC DCDC Converter

Suppression Switching Oscillation in Three-Phase Inverter with 1.7kv/300a SiC Modules

A Digital‐controlled Gate Charge Detection Circuit for Short‐circuit Protection and Condition Monitoring of SiC MOSFET

An Improved Switching Method-Based Diagnostic Strategy for IGBT Open-Circuit Faults in Hybrid Modular Multilevel Converters

Stator Inter-Turn Fault Detection in Closed-Loop Controlled Drive Based on Switching Sideband Harmonics in CMV

Open-Circuit Switch Fault Diagnosis and Fault- Tolerant Control for Output-Series Interleaved Boost DC–DC Converter

An Observer-Based Switch Open-Circuit Fault Diagnosis of DC-DC Converter for Fuel Cell Application

A Compact Gate Control and Voltage-Balancing Circuit for Series-Connected SiC MOSFETs and Its Application in a DC Breaker

Short-Circuit and Over-Current Fault Detection for SiC MOSFET Modules Based on Tunnel Magnetoresistance with Predictive Capabilities

Optically-Triggered Adaptive Zero-Voltage-Switching: Method and Response Analysis

Short-Circuit Fault Adaptive Analysis and Protection for SiC MOSFETs

Event-Driven Approach with Time-Scale Hierarchical Automaton for Switching Transient Simulation of SiC-Based High-Frequency Converter

Detection and Identification of Power Switch Failures Using Discrete Fourier Transform for DC–DC Flying Capacitor Buck Converters

Survey of Switch Fault Diagnosis for Modular Multilevel Converter

Simultaneous Mitigation of Switching Overvoltage and Oscillation for SiC MOSFET via Gate Charge Injection Concept

Investigation of Switching Oscillations for Silicon Carbide MOSFETs in Three-Level Active Neutral-Point-Clamped Inverters

Switch Open-Circuit Fault Diagnosis Method Using Bridge Arm Midpoint Voltage Integral for LLC Resonant Converter

Detection and Isolation of Multiple Faults in a Modular Multilevel Converter Based on a Sliding Mode Observer

An Open-Circuit Fault Detection Method of PMSM Fed by Dual Inverter with High Robustness

A Simple Switching-Event Dependent High-Frequency Sampling Method for Power Conversion System