Abstract:A novel digital current control strategy for digitally controlled DC-DC switching converters, referred to as Adjacent Cycle Sampling (ACS), is proposed in this paper. For the ACS current control strategy, the available time interval from sampling the current to updating the duty ratio, is approximately one switching cycle. In addition, it is independent of the duty ratio. As a result, the contradiction between the processing speed of the hardware and the transient response speed can be effectively relaxed by using the ACS current control strategy. For digitally controlled buck DC-DC switching converters with trailing-edge modulation, digital current control algorithms with the ACS control strategy are derived for three different control objectives. These objectives are the valley, average, and peak inductor currents. In addition, the sub-harmonic oscillations of the above current control algorithms are analyzed and eliminated by using the digital slope compensation (DSC) method. Experimental results based on a FPGA are given, which verify the theoretical analysis results very well. It can be concluded that the ACS control has a faster transient response speed than the time delay control, and that its requirements for hardware processing speed can be reduced when compared with the deadbeat control. Therefore, it promises to be one of the key technologies for high-frequency DC-DC switching converters.

A Simple Switching-Event Dependent High-Frequency Sampling Method for Power Conversion System

Sampled-Data Control with Adjustable Switching Frequency for DC–DC Converters

Design of High Accuracy High Conversion Ratio Single-Stage Switching Power Converter for Modern FPGAs at 10Mhz

High Digitalized Resolution and Low Switching Loss for High Power Electronics Converters Based on Multisampling Technology

High Resolution Digital Pulse Width Modulation Design For Digital Dc-Dc Converter

Digitally Current Controlled DC-DC Switching Converters Using an Adjacent Cycle Sampling Strategy

Alternating Current And Alternating Voltage Transducer Based On Instantaneous Value Sampling

Fast-Response Variable Frequency DC-DC Converters Using Switching Cycle Event-Driven Digital Control

Digitally controlled DC-DC switching converters using adjacent cycle sampling method

MPSoC-Based Dynamic Adjustable Time-Stepping Scheme with Switch Event Oversampling Technique for Real-time HIL Simulation of Power Converters

Multifunction Control Strategy for Single-Phase AC/DC Power Conversion Systems with Voltage-Sensorless Power-Decoupling Function

Digital Voltage Sampling Scheme for Primary-Side Regulation Flyback Converter in CCM and DCM Modes

Research on a DC-current sampling strategy

Novel Sampling Algorithm for Dsp Controlled 2 Kw Pfc Converter

Study of Multisampled Multilevel Inverters to Improve Control Performance

A Digital Control Scheme for PSR Flyback Converter in CCM and DCM

Power-Efficient Sampling

A technique to enable frequency dependent power savings in a level crossing analog-to-digital converter

A Digital Controller IC for High-Frequency DC-DC Switching Converters

Sampled-Data Modeling for PCM and ZVS Controlled Critical Conduction Mode (crcm) Active Clamp Flyback (ACF) Converter at Variable Switching Frequency.