Abstract:Due to the rapid adoption of Electric Vehicles (EVs) worldwide, On-Board/Off-Board Battery Chargers are facing numerous. One challenge is charging time since petrol and diesel vehicles are charged 10 times faster than electric vehicles. A second challenge is power density especially for the on-board chargers where minimal space for installation is allocated inside the vehicles. Another challenge is the wide battery voltage range which makes it difficult to optimize the converter over the entire battery voltage range and efficiency drops when either the battery voltage is too high or too lo.. Finally, the bi-directional operation is a challenge to allow the EV to support the grid in peak periods or even standalone loads. In this paper, a 6.6 kW two-stage structure is proposed utilizing a variable dc-link voltage operation. One of the most promising challenges in high-power applications is implementing the magnetics component into Printed Circuit Boards (PCBs). PCB winding transformers are widely in use in low power applications. Compared with conventional Iitz-wire transformers, the manufacturing process is greatly simplified and the parasitic is easier to control. However, due to the limitation of high winding loss and high multi-layer PCB cost in high power applications, the transformer design with PCB winding becomes a challenge. Emerging wide-bandgap devices provide the opportunity to adopt PCB transformers into high power applications. In addition, the low inductance requirement brought by high frequency also makes possible the realization of magnetic integration in PCB transformers.

28.4 Cc Ultra-Density 65 W Type-C Adaptor with Current Mirror Integration Method

A 93.4% Efficiency 42cc Type-C Power Delivery Adaptor with PMOS Integration Power Line Extension Method.

A GaN-based MHz Active Clamp Flyback Converter with Adaptive Dual Edge Dead Time Modulation for AC-DC Adapters.

A Digital PWM Controller of MHz Active Clamp Flyback with GaN Devices for AC-DC Adapter.

A new topology of asymmetric half bridge for 135W-level type-C power delivery application.

High Power Density Z-Source Resonant Wireless Charger with Line Frequency Sinusoidal Charging

A High-Efficiency Active Clamped Flyback AC-DC Converter Using an Integrated Digital Isolator in Isolated Communication

Bi-directional On-Board Charger Architecture and Control for Achieving Ultra-High Efficiency with Wide Battery Voltage Range

A High-Efficiency High-Density Wide-Bandgap Device-Based Bidirectional On-Board Charger

A High Density 400 W DC/DC Power Module with Integrated Planar Transformer and Half Bridge GaN IC

High-Frequency High-Density Bidirectional EV Charger

A High Frequency High Efficiency GaN Based Bi-Directional 48V/12V Converter with PCB Coupled Inductor for Mild Hybrid Vehicle

Design of CRM AC/DC Converter for Very High-Frequency High-Density WBG-based 6.6kw Bidirectional On-Board Battery Charger

An 8A 998A/inch<SUP>3</SUP> 90.2% Peak Efficiency 48V-to-1V DC-DC Converter Adopting On-Chip Switch and GaN Hybrid Power Conversion

A high efficiency bridgeless flyback PFC converter for adapter application

Design of Ac/dc Converter for Bidirectional On-Board Battery Charger with Minimizing the Amount of SiC MOSFET

High efficiency hybrid multi-stage adaptor with AC and DC input capability

A High Power Density 3-Phase/1-phase Compatible MISN-PFC Converter for On-Board Charger

A Gallium Nitride Integrated Power Module with Ultra-low Parasitic Inductances and Thermal Resistance

A High-Efficiency High-Power-Density SiC-Based Portable Charger for Electric Vehicles

A 36-55 V Input 0.6-2.5 V Output Bypass-Assist Series-Capacitor Power Converter with 93.1% Peak Efficiency and 1.5 Ma-5 A Load Range.