Abstract:Lead chalcogenides are dominant thermoelectric materials in the medium-temperature range due to their highly favorable electronic band structures and low thermal conductivities. An important system is the PbTe-PbS pseudo-binary, and its low thermal conductivity originates largely from the coexistence of both alloying and nanostructuring through phase-separation. To better understand the competition between the alloying and phase separation and its pronounced effects on the thermoelectric performance in PbTe-PbS, we systematically studied, via transmission electron microscopy (TEM) observations and theoretical calculations, the samples of Spark Plasma Sintered (SPSed) 3 at% Na-doped (PbTe)(1-x)(PbS)(x) with x = 10%, 15%, 20%, 25%, 30% and 35%. The highest figure of merit, viz., ZT similar to 2.3 was obtained at 923 K, when the PbS phase-fraction, x, was 20%, which corresponds to the lowest lattice thermal conductivity of the series. The consistently lower lattice thermal conductivities in the SPSed samples as compared with the corresponding ingots originates from the mesostructured nature of the former, which contributes significantly to their superior ZT. We also studied the onset of carrier concentration modulation at similar to 600 K, which leads to the observed saturation of electrical transport properties due to the diffusion and re-dissolution of excessive Na into the PbTe-PbS matrix. This carrier concentration modulation is equally crucial to achieve very high power factors (up to 26.5 mW cm(-1) K-2 at 623 K) and outstanding thermoelectric performances in SPSed PbTe-PbS binaries.

Achieving glass-like lattice thermal conductivity in PbTe by AgBiTe<sub>2</sub> alloying

Lattice thermal transport in group II-alloyed PbTe

High-Density Arrangement of Nanoscale Regions with Tellurium Interstitial Atoms and Silver/Copper Vacancies in AgCuTe Thermoelectric Materials

Reduced thermal conductivity in Pb-alloyed AgSbTe_2thermoelectric materials

Band convergence and nanostructure modulations lead to high thermoelectric performance in SnPb0.04Te-y% AgSbTe2

Influence of Ag_2Te Doping on the Thermoelectric Properties of p-type Bi_(0.5)Sb_(1.5)Te_3 Bulk Alloys

Influence of Ag2te Doping on the Thermoelectric Properties of P-Type Bi0.5sb1.5te3 Bulk Alloys

Synergistic Suppression of Bipolar Effect and Lattice Thermal Conductivity Leading to High Average Figure of Merit in Bi 0.4 Sb 1.6 Te 3 Materials through Alloying with AgSbTe 2

Regulation of exciton for high thermoelectric performance in (Bi, Sb)2Te3 alloys via doping with Pb and multi-scale microstructure

Superior thermoelectric performance in PbTe-PbS pseudo-binary: extremely low thermal conductivity and modulated carrier concentration

Broadening temperature plateau of high zTs in PbTe doped Bi0·3Sb1·7Te3 through defect carrier regulation and multi-scale phonon scattering

Nanostructure and High Thermoelectric Performance in Nonstoichiometric AgPbSbTe Compounds: the Role of Ag

Band Modification and Localized Lattice Engineering Leads to High Thermoelectric Performance in Ge and Bi Codoped SnTe–AgBiTe2 Alloys

Evaluation on the Thermoelectric Cooling Ability of PbTe

Thermoelectric enhancement at low temperature in nonstoichiometric lead-telluride compounds

Low Thermal Conductivity and Improved Figure of Merit in Fine-Grained Binary PbTe Thermoelectric Alloys

Thermoelectric Properties of Ag Doped Pseudo-binary Alloys (PbTe)1-x(SnTe)x

Improved Thermoelectric Properties of BiSbTe-AgBiSe 2 Alloys by Suppressing Bipolar Excitation

Approaching the Minimum Lattice Thermal Conductivity of P-Type SnTe Thermoelectric Materials by Sb and Mg Alloying.

Ioffe-Regel Limit And Lattice Thermal Conductivity Reduction Of High Performance (Agsbte2)(15)(Gete)(85) Thermoelectric Materials

Thermoelectric Performance of AgPb X SbTe 20 ( X = 17 to 23) Bulk Materials Derived from Large-Particle Raw Materials